EHX POG 2 Quick Start Manual

Congratulations on your purchase of the POG 2! The POG 2 is a Polyphonic Octave Generator that draws
its heritage from the now legendary POG, originally released in 2005 to worldwide acclaim. The POG 2 can
simultaneously generate multiple octaves from your input signal. Whether you play single notes, arpeggios
or full chords, the POG 2 will perfectly track every note you play. With the POG 2, you can mix together
your original "dry signal" with four different octaves: one octave above the original note, two octaves
above the original note, one octave below your original note and two octaves below the original note.
Additionally you can detune the two upper octaves, slow the attack on all voices including the dry signal
and process the overall tone through a low pass resonant filter with adjustable filter cutoff and selectable
Q. The POG 2 is fully programmable allowing you to store and load presets for performance and recording.
WARNING: Use only the 9.6 VDC 200mA adapter the POG 2 comes supplied with. Do not
use any other adapters. Using other adapters, even those made by Electro-Harmonix, could
cause harm to the unit, the adapter or you. The POG 2 does not use batteries.
DRY OUTPUT Slider – Controls the output volume of your original DRY signal before it exits the POG 2.
The DRY OUTPUT volume will increase as its slider is pushed upward.
-2 OCTAVES Slider – Controls the output volume of the signal 2 octaves below the input signal, which is
one quarter of the frequency of the input signal. As this slider is pushed upward, the volume of the -2
OCTAVE below the original pitch will increase. If you play a middle C note, this slider will control the
volume of the C note two octaves below middle C.
-1 OCTAVE Slider - Controls the output volume of the signal 1 octave below the input signal, which is
half the frequency of the input signal. As this slider is pushed upward, the volume of the -1 OCTAVE below
the original pitch will increase. If you play a middle C note, this slider will control the volume of the C note
one octave below middle C.
+1 OCTAVE Slider – Controls the output volume of the +1 octave signal. True to its name, the +1
OCTAVE signal is one octave above the original input signal. The +1 octave signal is twice the frequency of
the original input signal. The volume of the +1 OCTAVE will increase as this slider is pushed upward. If you
play a middle C note, this slider will control the volume of the C note one octave above middle C.
+2 OCTAVE Slider – Controls the output volume of the +2 octave signal. The +2 octave signal is two
octaves above the original input signal or four times the frequency of the original input signal. As this slider
POG 2
Polyphonic Octave Generator
-CONTROLS-