EHX DELUXE MEMORY MAN Manual

FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class
Note:
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment under FCC rules.
DELUXE MEMORY MAN
ANALOG DELAY WITH CHORUS/VIBRATO
Congratulations on your purchase of the Deluxe Memory Man with
Chorus/Vibrato. The Deluxe Memory Man is designed with state-of-the-art
solid state circuitry to give you years of high quality, trouble free
performance. The EH XO version of the Deluxe Memory Man is an exact
reissue of the original Deluxe Memory Man with one upgrade: true bypass.
Warning: Your unit comes equipped with a 24 Volt/100mA AC external
power adapter. Use only the power adapter supplied, and make sure it
is appropriate to your location (USA, Europe, Japan, Australia). Use of the
wrong adapter can cause damage to the unit or to you, and will void the
warranty. Connect the included 24DC/100mA AC Adapter to the Power Jack,
located at the top center of the Deluxe Memory Man.
- OPERATING INSTRUCTIONS and CONTROLS -
Connect your guitar to the INPUT jack, and the OUTPUT jack into the input of your
amp. Your Memory Man can be used in combination with other effects devices —
experiment to develop your own unique sound. The bypass footswitch on top of the
unit allows you to switch the effect in and out. Unmodified signal is always available
at the DIRECT OUT jack. Set the LEVEL control so that the OVERLOAD LED blinks
on with the loudest notes you play, but does not come on very brightly or too
frequently. Overdriving the unit will cause distortion.
The BLEND control allows you to vary the mix of direct and delayed signals; it is set
to the center position equal levels of both.
The FEEDBACK provides delay repeats, or multiple echoes. If set very high, runaway
oscillation will occur. Fairly high feedback with short delay settings produces a reverb
effect.
The DELAY control determines the time between direct and delayed signals, and
between the repeats when feedback is used. Strange, eerie and unusual pitch-shift
-POWER -