Advertisement
Quick Links
Advertisement
Related Manuals for Experia 12 00 01
Summary of Contents for Experia 12 00 01
- Page 1 Waterbed 12 00 01 12 00 02 12 00 13 Product Manual...
- Page 2 Congratulations on the purchase of your Waterbed. For optimal results, please read and follow instructions carefully Please ensure you read and follow these Instructions carefully before installing or operating the unit. Please keep this manual for future reference. Heed all warnings on the product and within this manual. If upon receipt of this product, the user suspects that the product is defective, and/or requires service or repair due to malfunction or damage to the product, please contact the manufacturer immediately.
-
Page 3: Installation
Positioning of your waterbed. It is advised not to position the waterbed hard up against a wall but to leave a gap of at least 50mm (5cm). If you have a plinth or base then please ensure they are level when in position. Installation If you have a base or plinth for your water bed position it where you intend the waterbed to be located. - Page 4 Before proceeding we advise you to test the heating element. This is done by connecting it up and switching on. Place your hand on the heating element and once you feel it getting warm switch it off. DO NOT LEAVE THE HEATING ELEMENT SWITCHED ON AS IT WILL CAUSE DAMAGE! Fit the safety liner (a thick vinyl sheet) inside the foam rectangle making sure the corners are positioned correctly in the corners of the foam.
- Page 5 Now fill you waterbed with water leaving a gap of approximately 20mm (2cm) below the top of the foam inserts. When “filled” the waterbed bladder should not be tight with water. Remove as much air in the waterbed as possible by pushing it out from the head of the bed towards the foot of the bed.
- Page 6 How to fill your waterbed without a pump. Before starting to fill your waterbed bladder check the positioning carefully because once the mattress is full of water it will be impossible to move. Using a suitable tap/faucet connector attach a hose pipe to your nearest available tap/faucet. Make sure it attached firmly and ensure the hose is clean.
- Page 7 How to drain you waterbed without a pump. If you need to move your waterbed or swap the heater you need to empty the waterbed bladder. A waterbed drain pump makes it easy to drain all of the water from the mattress, but a pump can seem like an unnecessary expense given how rarely most people use it.
-
Page 8: Troubleshooting
Cleaning and Maintenance The unit should be cleaned with a damp soft cloth. A non abrasive cleaning agent may be used for stubborn stains. No sharp objects should come into contact with the waterbed at any time. A full bottle of waterbed conditioner is required annually to help maintain the waterbed. If treated annually there is no requirement to replace the water. - Page 9 If you would like a FREE Sensory Brochure you can request one by telephone or visiting our website. For more information on Experia Free 3D Room Designs or to schedule an onsite visit from our sales team then please request a visit by telephone, email or by using the form on our website.
Need help?
Do you have a question about the 12 00 01 and is the answer not in the manual?
Questions and answers