Advertisement
Quick Links
IMPORTANT: All wiring connections must be made before switching on mains power.
Xicato LED Module
IP66 Dust tight and protected against powerful jets of water.
Please retain these instructions for future reference
This product should not be disposed of in your general waste
STOANE LIGHTING
Toad X
Installation and Maintenance
Instructions
410 381 1497 inter-lux.com answers@inter-lux.com
Inter-lux reserves the right to make technical changes without notice.
Class III - Extra-low voltage
Suitable for Exterior use
European Conformity
1
Advertisement
Related Manuals for Stoane Lighting Toad X
Summary of Contents for Stoane Lighting Toad X
- Page 1 Toad X Installation and Maintenance Instructions IMPORTANT: All wiring connections must be made before switching on mains power. Xicato LED Module Class III - Extra-low voltage IP66 Dust tight and protected against powerful jets of water. Suitable for Exterior use...
-
Page 2: Installation
The IP rating stated is applicable only when the fitting has been installed as per these instructions. Ensure supply driver and connectors are housed indoors OR in a suitable IP rated enclosure. STOANE LIGHTING 410 381 1497 inter-lux.com answers@inter-lux.com Inter-lux reserves the right to make technical changes without notice. - Page 3 For easier access to fixings rotate the fitting as shown. Connector 65mm STOANE LIGHTING 410 381 1497 inter-lux.com answers@inter-lux.com Inter-lux reserves the right to make technical changes without notice.
- Page 4 Step 3 Refit the lamp tube by screwing on in a clockwise direction. Check that the reflector is aligned centrally over the LED. Lamp tube Reflector Tilt STOANE LIGHTING 410 381 1497 inter-lux.com answers@inter-lux.com Inter-lux reserves the right to make technical changes without notice.
- Page 5 Use the Allen key as shown When reattaching the bezel, tighten gradually in the to be finger tight only sequence as shown in the diagram below. STOANE LIGHTING 410 381 1497 inter-lux.com answers@inter-lux.com Inter-lux reserves the right to make technical changes without notice.
- Page 6 Position the drainage hole at the bottom of the fitting. Remove the bezel. Loosen the 4 x M4 fixings to remove the snoot. STOANE LIGHTING 410 381 1497 inter-lux.com answers@inter-lux.com Inter-lux reserves the right to make technical changes without notice.
Need help?
Do you have a question about the Toad X and is the answer not in the manual?
Questions and answers