Eterna WELLBKSTD Installation Instructions

LED LAMP SPECIFICATIONS:

660 lm
Luminaire lumens (with diffuser)
900 lm
Lumens from chip (no diffuser)
660 lm
Useful lumens
Rated Wattage 10W
Rated luminous flux 660 lm
Nominal life time of the lamp 25,000 hrs
Colour temperature 4000K
Number of switching cycles
12,500
before premature lamp failure
Warm-up time up to 60% of the
Instant Full Light
full light output
Dimmable No
Nominal beam angle 120°
Rated power 10W
Rated lamp lifetime 25,000 hrs
Lamp power factor >0.5
Lumen maintenance factor at
70
end of nominal life
Starting time 0.5s
Colour rendering ≥80
Within a six step
Colour consistency
Macadam ellipse
Rated peak intensity 214cd
Rated beam angle 120°
Voltage / Frequency 240V~50Hz
Not suitable for accent lighting
EVENTUALLY, YOU MAY WANT TO
REPLACE THIS PRODUCT:
Regulations require the recycling of Waste from
Electrical and Electronic Equipment (European
"WEEE Directive" effective August 2005—UK
WEEE Regulations effective 2nd January 2007).
Environment Agency Registered Producer: WEE/
GA0248QZ.
WHEN YOUR PRODUCT COMES TO THE END OF
ITS LIFE OR YOU CHOOSE TO REPLACE IT, PLEASE
RECYCLE IT WHERE FACILITIES EXIST - DO NOT
DISPOSE WITH HOUSEHOLD WASTE.

LAMP REPLACEMENT:

The light source of this luminaire is not replaceable;
when the light source reaches its end of life the
whole luminaire shall be replaced.
Email: sales@eterna-lighting.co.uk / technical@eterna-lighting.co.uk
www.eterna-lighting.co.uk
Visit our website:
Issue 0519
MODELNO.
WELL_STD_PIR
874/2012

CLEANING:

Disconnect the power and clean the exterior only of
this fitting with a moist (not wet) cloth.
Do not use any chemical or abrasive cleaners.

IF YOU EXPERIENCE PROBLEMS:

If you believe your product is defective, please return
it to the place where you bought it. Our Technical
Team will gladly advise on any Eterna Lighting
product, but may not be able to give specific
instructions regarding individual installations.
Made in China
INSTALLATION INSTRUCTIONS
A guide for qualified electricians

Pack contents:

1 x Well glass fitting
1 x Corner & wall
bracket assembly
Model:
1 x Fixing kit
WELLBKSTD / WELLWHSTD
WELLBKPIR / WELLWHPIR
Polycarbonate LED Well Glass Fitting
With Optional Corner Bracket
These instructions are provided as a guideline to assist you.
PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLATION
AND RETAIN FOR FUTURE REFERENCE