Advertisement
Setting up MyPal
NOTE
Install the battery before connecting the AC adapter to a power source.
Refer to page 1-10 of the Handbook for proper battery installation.
Without the cradle
1.
Connect the power cable to the jack on the
sync cable adapter.
2.
Connect the 26-pin device plug of the sync
cable to the 26-pin connector on the bottom
of the device.
3.
Connect the power plug to a grounded wall
socket.
NOTE
The charging status LED blinks green.
When using the cradle
1.
Place the device on the cradle.
2.
Connect the power cable to the connector at the back of
the cradle.
3.
Connect the power plug to a grounded wall socket.
2
2
1
Cradle connector/
Sync cable connector
3
Charging status LED
Blinks green when battery is charging
Steady green when battery is fully
charged
Pocket PC
Device connector
3
1
Advertisement
