Related Manuals for Balboa Wavezone3NE
Summary of Contents for Balboa Wavezone3NE
- Page 1 INSTALLATION INSTRUCTIONS AND MAINTENANCE MANUAL BALBOA WAVEZO NE SANITITION SYSTEM BALBOA WATER GROUP www.balboawater.com 3030 Airway Avenue, Suite B – Costa Mesa - CA - 92626 – USA Rev20200511...
- Page 2 Introduction of Wavezo ne Combo – Powerful Sanitation Method & The Science Behind It: UVC radiation “kills” bacteria and viruses in the water exposed to the UV rays. Ozone (O ) is a powerful oxidant that oxidizes organics contaminants in water. UV generators and Ozone generators are being widely used for spa and hot tub applications today.
-
Page 3: Specifications
Dimensions: III. Specifications: OZONE SYSTEM LAMP RATED SYSTEM FLOW CONNECTION APPROVAL PART OZONE OUTPUT VOLTAGE WATTAGE AMPERAGE FREQUENCY RATE SIZE AGENCIES NUMBER CELL (0.8LPM) 59326 230V 0.5A 50/60Hz 6 GPM 50 mg/h 3/4” BARB UL/cUL/CE/RCM 59327 230V 0.5A 50/60Hz 6 GPM 3/4”... - Page 4 Mounting: This unit can be mounted on the spa floor or on the spa wooden frame with ozone outlet facing up. The unit has two mounting tabs with 2x holes on each tab. Use 4x #8x1” screws to bolt the unit to the spa floor or spa wooden frame.
-
Page 5: Exploded Drawing
Option 3: VII. Electrical Connections: Danger: Turn the spa breaker to OFF position. This unit must be connected to dedicated UV/Ozone mating connector on the spa controller’s circuit board. Electrical ratings are shown on the product label. This unit must be powered as rated only. Verify electrical ratings of this unit and spa controller before making connections. - Page 6 Maintenance: Quartz tube (15) to be cleaned every six (6) months of usage. Quartz tube (6) cleaning instructions: Danger: Turn the spa breaker to OFF position. Open the spa controller’s cover and disconnect the unit from the spa controller. Drain the spa Warning: Allow UV-C lamp (10) to cool down prior to removing from the unit.
- Page 7 Reconnect the unit to the spa controller and reinstall the spa controller’s cover. Turn ON the power to the spa. Once power is activated you can check the LEDs to see if the unit is functioning. A solid green light indicates the unit is being provided power and should always be on.