Solaris LoCor Recessed Electronic Dispenser User Manual
  1. Manuals
  2. Brands
  3. Solaris Manuals
  4. Dispenser
  5. LoCor Recessed Electronic Dispenser
  6. User manual

Solaris LoCor Recessed Electronic Dispenser User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

SOLARIS LOCOR® RECESSED ELECTRONIC ROLL TOWEL DISPENSER USER GUIDE (SKU NUMBERS D68011-A)
The LoCor Recessed Electronic Dispenser is designed to be mounted into the wall or inside a recessed cabinet on the wall to yield maximum space in the
busy bathroom environment. The paper is delivered automatically by positioning a hand underneath the center bottom of the dispenser. The remaining
roll towel is maintained inside the unit to avoid cross contamination. With the stainless steel cover, the dispenser offers both attractive appearance and
easy cleaning ability; all together providing a maximum sanitation.
Outer dimension is 18.17" x 14.67" x 10.97", weighs approximately 9.8 lbs.
The dispenser is designed for an opening of 10 5/8" Width x 15 1/8" Length x 4" Depth.
TABLE OF CONTENT
I.
Dispenser Installation Instruction .........................................................................................................................
1. Install Directly into the Wall - Using A Picture-Frame Panel .............................................................
2. Install into Existing Recessed Cabinets on the Wall - Using Filler Panels .........................................
2a. Use Insert Filler Panel ......................................................................................................
2b. Use Hanging Filler Panel ..................................................................................................
II. Changing Mounting Side of Cover ..........................................................................................................................
III. Roll Support Installation ..........................................................................................................................................
2. For 8" Width Solaris LoCor Paper Towel SKU Numbers 46896, 46901 ............................................
IV. Power-up the Dispenser .........................................................................................................................................
V. Paper Loading and Initiate the First Dispense ....................................................................................................
VI. Switch Control Settings ...........................................................................................................................................
VII. LED Indicator Light Function .................................................................................................................................
VIII. Stub-Roll Transfer Loading ......................................................................................................................................
IX. Failure Diagnostics ...................................................................................................................................................
Page 2
Page 2
Page 4
Page 5
Page 5
Page 7
Page 8
Page 8
Page 8
Page 9
Page 9
Page 10
Page 10
Page 10
Page 10
1
8777002
Released February 22 2019

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LoCor Recessed Electronic Dispenser and is the answer not in the manual?

Questions and answers

Related Manuals for Solaris LoCor Recessed Electronic Dispenser

Summary of Contents for Solaris LoCor Recessed Electronic Dispenser

  • Page 1: Table Of Contents

    SOLARIS LOCOR® RECESSED ELECTRONIC ROLL TOWEL DISPENSER USER GUIDE (SKU NUMBERS D68011-A) The LoCor Recessed Electronic Dispenser is designed to be mounted into the wall or inside a recessed cabinet on the wall to yield maximum space in the busy bathroom environment. The paper is delivered automatically by positioning a hand underneath the center bottom of the dispenser. The remaining roll towel is maintained inside the unit to avoid cross contamination.

  • Page 2: Dispenser Installation Instruction

    I. DISPENSER INSTALLATION INSTRUCTION Recommend to use a pencil outlining the opening before cutting into the drywall: Using a tape measure, place a mark of 48” from the floor. Then use a 1. Install Directly into the Wall – Use A Picture-Frame Panel level to draw a horizontal line from the mark.
  • Page 3 supporting studs Figure 2. Step 4: Install the Two Supporting Studs Install the two studs (2” x 4” x 12”L) on the left side and right side of screw# 10 in step 4 the opening, behind the drywall (Figure 2). Drive three screws #10 (1 1/2" L ) through the drywall into each stud on both sides (total of six screws to be used).
  • Page 4 2. Install into Existing Recessed Cabinets on the Wall – Use Filler Here are some examples of the existing recessed dispensers: Panels Recessed Paper Towel Dispenser secured by screws/nuts Tools and materials required (not provided): Power Drill with: Phillips Head Drive Open the cover and 1/4”...

  • Page 5: 2A. Use Insert Filler Panel

    Step 2: Filler Panel Installation b. Use Hanging Filler Panel a. Use Insert Filler Panel Hardware provided with the Hanging Filler Panel: Hardware provided with the Insert Filler Panel: (4) Screws #6 x 1 1/4”L, Phillips Head (4) Screws #8 x 3/4”L, Hex Head (3) Double Sided Tape Strips (4) Screws #6 x 1 1/4”L, Phillips Head Remove the protecting film on the outside of the panel.
  • Page 6 Step 3: Dispenser Installation Hardware provided with the dispenser: (4) Screws #10 x 1”L, Phillips Head (4) Wall Anchors Through the front opening of the panel, slide the dispenser all the way in, make sure that the back of the dispenser is in contact evenly with the back of the cabinet.

  • Page 7: Changing Mounting Side Of Cover

    Top Hinge CHANGING MOUNTING SIDE OF COVER E-clip The cover is designed to be mounted on either left or right side of the Removable Hinge housing. Manufacturing setting is left-side mounting. To change to right-side mounting, follow steps 1 - 5: Step 1: Remove Hinge Pins (Top &...

  • Page 8: Roll Support Installation

    III. ROLL SUPPORTS INSTALLATION The dispenser is designed to accept both the 7” and 8” wide LoCor Roll Towels. It is very important to identify the width of the paper roll before installing the Roll Supports: SKU Numbers for 7” Width LoCor Paper Towel: 46897, 46898, 46899, 46902 SKU Numbers for 8”...

  • Page 9: Power-Up The Dispenser

    DC JACK STUB ROLL SUPPORTS IV. POWER-UP THE DISPENSER For use with LoCor paper towels only (SKU numbers 46896, 46897, 46898, 46899, 46901 and 46902). Other types of paper are not acceptable. Power-up the Dispenser Using Batteries Recommend to use the four batteries provided with the dispenser or use D-size alkaline batteries labeled with "LR20"...

  • Page 10: Switch Control Settings

    If using batteries, the LED light will flash one time after the batteries are installed VI. SWITCH CONTROL SETTINGS correctly to indicate that the unit is powered up. The LED light will also flash once after every dispense to indicate the unit is ready for the next use. When the There are three switches available to customize the control system.

This manual is also suitable for:

D68011-a

Table of Contents