Barudan BEXS Instruction Manual page 180

Message
(Code)
D01 Needle Bar Not Locked
Color Change Lock Error
D03
D04 Color
Sensor Error
D05 Color Change Error
Description
Change Needle
Trouble shooting
Color Change Lock sensor is not engaged or not
working properly. Manually rotate the Color change
assembly so the sensor plate engages the Lock
sensor and retry. If still a problem look to see if the
Sensor LED is working. If the Color Change
assembly is in a bind or jammed, do not force. See
Error D05 for possible binds.
Color Change Lock sensor is not engaged or not
working properly. Manually rotate the Color change
assembly so the sensor plate engages the Lock
sensor and retry. If still a problem look to see if the
Sensor LED is working. If the Color Change
assembly is in a bind or jammed, do not force. See
Error D05 for possible binds.
Needle Select Board in Color Change Assembly has a
sensor for each needle. One sensor at a time should
always be engaged and On. First manually rotate
the Color change assembly to see if it clears up the
problem. Do not force if color change is in a bind. See
Error D05 for possible binds. If no binds and still
getting this error, check the Needle select board to
see if the sensor plate is bent or if any of the sensors
are broken. Replace the Needle select board.
Machine had an error trying to make a color change.
Manually rotate the color change assembly to see if
there are any binds in the color change movement.
Possible Binds.
1. One or more of the thread keep solenoids is stuck
or out of position causing it to jam a head from
moving.
2. One or more of the Jump solenoids is not
engaging
3. One or more take up levers are broken.
4. Sewing head side cover is interfering with head
movement.
5. The Degree wheel is the wrong position.
Correct any of these conditions before continuing.
May need to power down and back On to reset the
machine, afterwards.
１３‐７