General Information - Helios AIR1-KP Installation And Operating Instructions Manual

Installation and Operating Instructions
EN
CHAPTER 1
GENERAL
INFORMATION
m
m
DANGER
m
WARNING
m
CAUTION
ATTENTION
ATTENTION
Condensate pump AIR1-KP
1.1 Important information
In order to ensure correct operation and for your own safety, please read and observe
the following instructions carefully before proceeding. Relevant national standards, safety
regulations and provisions (e.g. DIN EN VDE 0100) as well as the technical connection
conditions of the energy supply company must be observed and applied.
Keep the operating instructions close to the unit for easy reference. The document must
be issued to the operator (tenant/owner) after the final assembly.
1.2 Warning and safety instructions
The adjacent symbol is a safety-relevant prominent warning label. All safety re-
gulations and/or symbols must be absolutely adhered to, so that any dangerous
situation is avoided.
m
DANGER
Indicates dangers which will directly result in death or serious injury if the safety instruc-
tion is not followed.
m
WARNING
Indicates dangers which will result in death or serious injury if the safety instruction is not
followed.
m
CAUTION
Indicates dangers which can result in injuries if the safety instruction is not followed.
ATTENTION
Indicates dangers which can result in material damage if the safety instruction is not followed.
1.3 Warranty claims – Exclusion of liability
Our warranty shall not apply if the following instructions are not observed. The same
applies for liability claims against the manufacturer. The use of accessories which are
not recommended or offered by Helios is not permitted. Any damage that may occur is
not liable for warranty.
1.4 Regulations – Guidelines
If the product is installed correctly and used to its intended purpose, it conforms to all
applicable regulations and EC guidelines at its date of manufacture.
1.5 Receipt
Please check delivery immediately on receipt for accuracy and damage. If damaged,
please notify the carrier immediately. In case of delayed notification, any possible claim
may be void.
1.6 Storage
When storing for a prolonged time the following steps are to be taken to avoid damaging
influences:
Protection by dry, air- dustproof packing (plastic bags with drying agent and moisture
indicators). The storage place must be waterproof, vibration-free and free of excessive
temperature variations (-20 to +60 °C). Damages due to improper transportation, storage
or commissioning are verifiable and not liable for warranty.
1.7 Intended use
Condensate that accumulates in the ventilation unit due to heat recovery can be drained with
the condensate pump.
The condensate pump AIR1-KP can be connected to AIR1 ventilation units in series XC
and to the corresponding cooling elements (Helios range).
Any use other than the intended use is prohibited!
1