LOXONE Miniserver Go Quick Start Manual page 2

About the product
The Miniserver Go is a device for the automatic control and
management of home automation and similar non safety
critical applications. The Loxone Miniserver Go has a fully
integrated Air Base Extension and is perfect for retrofitting
Loxone in existing homes.
Installation & electrical connection
Connect device only to the power supply that is shipped with
the product. Do not connect the device to telecommunication
networks.
If the unit is used in a non conform manner as specified by
the manufacturer the product included safeguards will be
impaired.
Information
Contains FCC ID: COR-ZWIR4512AC1
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received,
including interference that may cause undesired operation
This folder is a part of the product!
For additional information, declaration of confirmity,
visit www.loxone.com/help/miniserver-go
Connection
Wire Diameter 0.2...1.5mm² /
AWG24...AWG16
8mm / 0.31"
Exposed Wire Length
Push-In-Technology To make connection, insert
wire; to remove the wire,
twist and pull at the same
time
Specifications
Status
LED
GND Link
Micro LAN
SD Connector
Connect Extension
GND
N L
24VDC
Power Supply
Power via
Micro USB
Keep in mind that GND needs to be
connected to the ground of
the 24V Power.
Miniserver Go
Link
EXT EXT EXT
120˜ t ermination
resistor