Subscribe to Our Youtube Channel
Related Manuals for urmet domus FDi TRANSIT+
Summary of Contents for urmet domus FDi TRANSIT+
- Page 1 Installation guide 50-001-807 FDI MATELEC SA Route de St Symphorien 85130 Les landes Génusson – France www.fdimatelec.com...
-
Page 2: Table Of Contents
Installation guide Content Overview ............................3 Features ........................... 3 Hardware ..........................3 1.2.1 Controllers ........................3 Transit + manager ........................3 Installation ............................4 Wiring diagram ........................4 2.1.1 PSU and readers ......................4 2.1.2 Lock ..........................5 2.1.3 Maintenance mode ......................6 Led indication .......................... -
Page 3: Overview
Installation guide 1 Overview This controller manages 5000 credentials which can be proximity keys or remote controls. The access is given 24/7, there is no time profile or validity period on this controller. 1.1 Features 2 doors 5000 credentials ... -
Page 4: Installation
Installation guide 2 Installation Controllers are designed to be wall mounted through 4 screws but can also be DIN rail mounted. A cover is supplied. 2.1 Wiring diagram The controllers communicate through BLE with the mobile phone. The USB plug is only used by the factory. -
Page 5: Lock
Installation guide 2.1.2 Lock When a fail-safe lock is used, a second security must be used to prevent an issue between the REX push button and the controller. Basically, a break glass is connected in serial with the lock psu or the push button manages two dry contacts : 1 NO contact for the controller REX input + 1 NC contact in serial with the lock or maglock psu. -
Page 6: Maintenance Mode
Installation guide Fail-safe lock / Maglocks Controller Leds Exit push button Diode or transil Electrical lock 2.1.3 Maintenance mode A maintenance mode is designed to easily test the system. In the following position of the jumper , the behavior of the controller is standard. Only authorized keys can open the door or activate floors. - Page 7 Installation guide Overview Controller Controller status Detail Door status Door For each door, the green led is ON when the relay is activated. The red led of a 2-Smart controller flashes once every 3secs when the reader communication is ok and flashes 3 times per sec in case of faulty communication (reader not connected) Leds...
-
Page 8: How To Start Programming
Installation guide 4 How to start programming? Prerequisite: Download and install the Transit+ App if required. The app manages two different menus: setup of the controller and management of the keys. The setting tab offers possibility to Change the name of the controller. By default, it is the ID but it can be changed to make the detection easier later Set the door release time of each relay Change the password of the controller. -
Page 9: Compatible Products
Installation guide 5 Compatible products All FDI Mifare Plus keys GB-010-200 Mifare Plus black key GB-010-228 Mifare Plus blue key GB-010-229 Mifare Plus red key GB-010-230 Mifare Plus green key GB-010-278 Mifare Plus yellow key FD-010-203 868 MHz Mifare Plus remote control 4 buttons FD-010-204 433 MHz Mifare Plus remote control 4 buttons All FDI 2 wire readers...
Need help?
Do you have a question about the FDi TRANSIT+ and is the answer not in the manual?
Questions and answers