Advertisement
Advertisement
Table of Contents
Related Manuals for wallas Nautic 40D
Summary of Contents for wallas Nautic 40D
- Page 1 WALLAS 40D Operator’s Manual and Installation Guide © 2010 Two Mac Inc.
-
Page 2: Operation
Operator’s Manual and Installation Guide Operation Nautic 40D is a marine diesel furnace with no open flame, intended for recreational use. Use as a live aboard product will mean more frequent servicing, not covered by warranty. The furnace extracts combustion air from the installation space through a slot in its base and blows the exhaust gases overboard. - Page 3 WALLAS 40D Operator’s Manual and Installation Guide Mounting the device Attach the furnace mounting bracket to the dampening plate (figure 2). Attach the dampening plate to the bulkhead (figure 3). Attach the furnace to the mounting piece by clicking the rails of the mounting piece to the grooves in the sides of the furnace (figure 4).
- Page 4 WALLAS 40D Operator’s Manual and Installation Guide Figure 2: Joining the mounting bracket and optional Figure 4: Attaching the furnace to the dampening plate. If purchased, the screws needed are mounting bracket. in the auxiliary bag of the dampening plate.
- Page 5 WALLAS 40D Operator’s Manual and Installation Guide...
- Page 6 WALLAS 40D Operator’s Manual and Installation Guide...
- Page 7 The use of a booster fan (P/N 3415) is recommended for ducts of excessive length. Information about the booster fan and its use is can be obtained from your Wallas dealer. All ducts over 3 ft. long, passing through unheated spaces should be insulated and...
- Page 8 Operator’s Manual and Installation Guide Inlet air ductlng Inlet air for the Nautic 40D furnace is taken through two 3 inch (75mm) air ducts. This allows the furnace to be installed in the engine compartment or other spaces where the air may be foul.
-
Page 9: Basic Control Panel
WALLAS 40D Operator’s Manual and Installation Guide the power lamp is lit, and the Operation Using Basic red heating lamp blinks. Control Panel After cooling all indicator lamps will go out. Heating The furnace starts when the Ventilation power switch is turned to the Turn the power switch to HEAT position. - Page 11 WALLAS 40D Operator’s Manual and Installation Guide Using an external thermostat on Nautic 40D furnace with #3004 control panel An external thermostat can connected to the #3004 control panel cable as shown in Figure 13. (Connector pin 7 grey wire). Because the current is small the wire thickness is not significant.
- Page 12 WALLAS 40D Operator’s Manual and Installation Guide Figure 14 Figure 15...
- Page 13 & miscellaneous adapters. If you purchase a Wallas day tank, these fuel line kits are not used, being replaced by a complete #367215 tank adapter kit. The #367215 kit has it’s own tank end filter.
-
Page 14: Installation Checklist
WALLAS 40D Operator’s Manual and Installation Guide Installation checklist: When choosing the place for the device, remember the need to detach it for service. Ensure sufficient air supply for the device.. Ensure sufficient circulation of air in the boat. Openings for incoming heating and ventilation air are placed at a minimum distance of 16" away from the fuel fill fitting and the tank breather fitting. -
Page 15: Warranty
• The instructions for installation, operation or maintenance have not been followed. • Storage or transport has been inappropriate. • A problem has resulted from an accident or damage, which Wallas has had no control over (force majeure). • Problems arise from normal wear and tear. The fan motors of the heaters (and ventilation hood assembly (85D+270) have a natural wear limit of 1500 hours. - Page 16 WALLAS 40D Operator’s Manual and Installation Guide June 2, 2010...