Advertisement
ETC Installation Guide
Keyswitch Station
Installing the Station in the Back Box
3.
Installing the Faceplate
The faceplate is secured to the station with two magnets that are located on
the bottom edge of the faceplate.
Using the Keyswitch
Turn the provided key to perform the configured event. Space lockout toggle
is the default action. Turn the key again to toggle the event off. Reference
Switches on page 2
Echo Keyswitch Station
a.
Fold the spacer in a zig-zag fashion and press them together to
achieve the required thickness to fill the gap between the
station, wall surface, and the back box.
b.
Cut off and discard the excess.
c.
Place the stack between the station electronics and the flush
mounted back box.
Secure the station with two screws. If using spacers, insert the screws
through the spacers as well.
1.
Align the top of the faceplate approximately 20
degrees to the station.
2.
Hook the top of the faceplate on the tabs located on
the top of the station electronics assembly. To ensure
the faceplate is hooked properly on the top hook,
wiggle it slightly side to side while the bottom is
angled about 20 degrees from the wall.
3.
Swing the bottom of the faceplate down until the
magnets engage.
4.
If the faceplate does not fully attach, wiggle the
bottom of the plate until the magnets are seated
properly to the station and the faceplate is secure.
for information to configure custom events.
1.
2.
Page 4 of 4
Insert the station
electronics and wiring into
the back box. The arrow on
the mounting plate must
point up.
Use receptacle spacers as
needed to provide a flush
mounted station. These
spacers are not required for
a surface mount
installation.
Electronic Theatre Controls, Inc.
DIP
Advertisement
