Subscribe to Our Youtube Channel
Related Manuals for Pakole ZENIT 70+
Summary of Contents for Pakole ZENIT 70+
- Page 1 User’s Manual PROPANE OR NATURAL GAS-FIRED ZENIT TUBE RADIANT HEATER Appliance types: ZENIT 70 + 12...48 kW www.pakole.com...
-
Page 2: Table Of Contents
ZENIT Contents TYPE TUBE RADIANT HEATER Contents Safety information ���������������������������������������������������������������������������������������������� 3 General Instruction �������������������������������������������������������������������������������������������� 4 Installer’s responsibilities ......................4 Data board ............................ 4 Corrosive materials ........................5 Standards and laws ........................5 Safety signs ..........................5 Safe usage ............................ 5 Transportation, unpacking, handling ��������������������������������������������������������������... -
Page 3: Safety Information
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Safety information Read and understand this manual thoroughly before installing starting or servicing this equipment. The improper installation or using can cause serious damages! Keep this manual in a safe place in order to obtain information in case of incidental problems! GENERAL SAFETY NOTICES Disregard of instructions and notices of this Manual can cause serious bodily injuries or damages... -
Page 4: General Instruction
The appliance is equipped with data board, which is placed on outside of device’s door. On this data board there are information con- cerning the type of device, gas type, electrical connection and flue types. Manufacturer Type Zenit-28/L/70+ PAKOLE Trade Kft. 8000 Székesfehérvár, Nominal input: 28 kW Börgöndi út 8-10. -
Page 5: Corrosive Materials
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Corrosive materials ATTENTION! Do not use the appliance in such place where corrosive materials can be in the air! If the appliance has to be applied in this circumstances outside air has to be ensured for combustion air! The manufacturer can not assume responsibility for fault of equipment in case the installation is not happened according to the above. -
Page 6: Transportation, Unpacking, Handling
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER ATTENTION • Never use the unit to support other equipment. • Never leave tools, spare parts, etc. inside the unit. • Make sure that all inspection panels are closed properly. •... -
Page 7: Installation
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Installation Components of „I” -form tube radiant heater Spacer plate Isolation cover Isolation Reflector Flue gas analyzer nozzle Combined hanger Radiant tube End cap Lower clip Burner Burner hanger Electric connector Burner fixing clamp 2. -
Page 8: Appliance Installation
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Appliance installation • SOLELY INTERIOR installation is possible. • The installation must comply with the valid standards. • For the sake of appropriate efficiency the position and the high of installation has to be carefully defined. •... -
Page 9: Regulatory Options
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Regulatory options Electrical connection scheme of HONEYWELL S4965R automatic burner control 16. picture: Connection points of S4965R automatic burner control Electrical connection scheme of SIT 579 DBC automatic burner control 12 11 10 14 13 SAFETY... -
Page 10: Optional Accessories
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Optional accessories Thermostat Recommended temperature controllers for the appliance (these can be purchased at the appliance manufacturer) FP-1D FP-3D 2-point regulation thermostat 3-point regulation thermostat with weekly hour programming Temperature sensor FP-4D FP-MOD 2-point regulation thermostat... -
Page 11: Control Of Appliance
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Control of appliance The ZENIT tube radiant heater can be controlled manually or automatically. At manual control: The electrical supply of appliance is interrupted manually, based on sense of temperature: Centrally, at each heating zones by a common box Individually, at each appliances separately. -
Page 12: Protective Distances
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Protective distances From flammable materials it is obligatory to keep SAFETY OF OPERATION and FIRE PREVENTION distances! ATTENTION! The specified fire-protection distances – Pic. 21 – must be strictly kept and checked! The installation must comply with the valid standards! Disregard of these instructions can result in death, injury or property damage! Heat-radiated area... - Page 13 ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER The minimal mounting height Tube Minimum installation height for input power ZENIT location 10 kW 15 kW 20 kW 25 kW 30 kW 35 kW 40 kW 45 kW 50 kW 55 kW 60 kW „U”...
-
Page 14: Combustion-Air Supply
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Combustion-air supply Combustion air may be drawn in from more spaces: • from inside (heated) space, • from outside, in case outside combustion-air system is connected to the fan. The combustion air must not drawn in from internal space in the following cases: •... -
Page 15: Air Supply And Venting System Types
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Air supply and venting system types Exhaust arrangements of combustion products • Flue channel to the outside of building at each appliance • Common flue channel for two appliances Flue pipe is not allowed to have a low point, it must be made of Ø100mm stainless steel or aluminium. The minimum ascent of flue piping must be 2cm/m≈1°... -
Page 16: Appliance Specification
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Appliance specification Start, restart Following the switched on voltage the fan operates continuously assuring the 30 seconds pre-purge time. This time period ensures the three times air change of combustion volume in case of biggest appliance’s power. When the pressure is suitable - after 30 seconds –... -
Page 17: Operation Of Automatic Burner Control (Sit 579 Dbc)
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER The flame sensor is self-monitoring and only performs an intervention on the burner it controls, insensitive to other environmental effects (eg.: external heat, light) Following the switched on voltage the fan operates continuously assuring the 30 seconds pre-purge time. This time period ensures the three times air change of combustion volume in case of biggest appliance’s power. -
Page 18: Maintenance Supervisions By A Qualified Service Department
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER ATTENTION! Before any maintenance operation the appliance must be disconnected from the power supply by turn off the electrical main switch and pull out the electrical plug on the back of the appliance. ATTENTION! In case operational circumstances of appliance (atmosphere is contaminated with corrosive substances, dirt etc.) need it, then supervision and cleaning may have done more often! The main reason of this that the settled dirt on the radiant tubes can damage... -
Page 19: Enclosure
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Enclosure Enclosure 1.: Variety-list of ZENIT 70+ -type tube radiant heaters Minimum and maximum pipe lengths allowed for full power: ZENIT selection list of tube radiants with 2-point control Full length (m) Input Type Power... - Page 20 ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Minimum and maximum pipe lengths allowed for full power: ZENIT 3-point or modulation control selection list of tube radiants with Full length (m ) Input (kW) Type Power (input power) 10.5 (kW) 12.6...8.9...
-
Page 21: Enclosure 2.: Heating And Consumption Values Of Zenit 70+ Tube Radiant Heaters
ZENIT Instructions for Installation and Servicing TYPE TUBE RADIANT HEATER Enclosure 2.: Heating and consumption values of ZENIT 70+ tube radiant heaters 2 point..Gas consumption Input power Type kg/h (kW) Natural gas Propane-Butane Propane ZENIT 70+ - 12 1.32 1.05 1.02 12.6... - Page 22 - Single stage (ON-OFF) output At minimum heat 0.06 - Two stage (100%-60%-OFF) output In standby - Modulated mode Permanent pilot flame power requirement Pilot flame pow- er requirement pilot (if applicable) Contact PAKOLE Trade Kft. H-8000, Székesfehérvár, Börgöndi út, 8-10 details...
- Page 23 - Single stage (ON-OFF) output At minimum heat 0.06 - Two stage (100%-60%-OFF) output In standby - Modulated mode Permanent pilot flame power requirement Pilot flame pow- er requirement pilot (if applicable) Contact PAKOLE Trade Kft. H-8000, Székesfehérvár, Börgöndi út, 8-10 details...
- Page 24 - Single stage (ON-OFF) output At minimum heat 0.06 - Two stage (100%-60%-OFF) output In standby - Modulated mode Permanent pilot flame power requirement Pilot flame pow- er requirement pilot (if applicable) Contact PAKOLE Trade Kft. H-8000, Székesfehérvár, Börgöndi út, 8-10 details...
- Page 25 - Single stage (ON-OFF) output At minimum heat 0.06 - Two stage (100%-60%-OFF) output In standby - Modulated mode Permanent pilot flame power requirement Pilot flame pow- er requirement pilot (if applicable) Contact PAKOLE Trade Kft. H-8000, Székesfehérvár, Börgöndi út, 8-10 details...
- Page 26 - Single stage (ON-OFF) output At minimum heat 0.06 - Two stage (100%-60%-OFF) output In standby - Modulated mode Permanent pilot flame power requirement Pilot flame pow- er requirement pilot (if applicable) Contact PAKOLE Trade Kft. H-8000, Székesfehérvár, Börgöndi út, 8-10 details...
- Page 27 - Single stage (ON-OFF) output At minimum heat 0.06 - Two stage (100%-60%-OFF) output In standby - Modulated mode Permanent pilot flame power requirement Pilot flame pow- er requirement pilot (if applicable) Contact PAKOLE Trade Kft. H-8000, Székesfehérvár, Börgöndi út, 8-10 details...
- Page 28 - Single stage (ON-OFF) output At minimum heat 0.06 - Two stage (100%-60%-OFF) output In standby - Modulated mode Permanent pilot flame power requirement Pilot flame pow- er requirement pilot (if applicable) Contact PAKOLE Trade Kft. H-8000, Székesfehérvár, Börgöndi út, 8-10 details...
- Page 29 - Single stage (ON-OFF) output At minimum heat 0.06 - Two stage (100%-60%-OFF) output In standby - Modulated mode Permanent pilot flame power requirement Pilot flame pow- er requirement pilot (if applicable) Contact PAKOLE Trade Kft. H-8000, Székesfehérvár, Börgöndi út, 8-10 details...
- Page 30 - Single stage (ON-OFF) output At minimum heat 0.06 - Two stage (100%-60%-OFF) output In standby - Modulated mode Permanent pilot flame power requirement Pilot flame pow- er requirement pilot (if applicable) Contact PAKOLE Trade Kft. H-8000, Székesfehérvár, Börgöndi út, 8-10 details...
- Page 31 - Single stage (ON-OFF) output At minimum heat 0.06 - Two stage (100%-60%-OFF) output In standby - Modulated mode Permanent pilot flame power requirement Pilot flame pow- er requirement pilot (if applicable) Contact PAKOLE Trade Kft. H-8000, Székesfehérvár, Börgöndi út, 8-10 details...
- Page 32 - Single stage (ON-OFF) output At minimum heat 0.06 - Two stage (100%-60%-OFF) output In standby - Modulated mode Permanent pilot flame power requirement Pilot flame pow- er requirement pilot (if applicable) Contact PAKOLE Trade Kft. H-8000, Székesfehérvár, Börgöndi út, 8-10 details...
- Page 33 - Single stage (ON-OFF) output At minimum heat 0.06 - Two stage (100%-60%-OFF) output In standby - Modulated mode Permanent pilot flame power requirement Pilot flame pow- er requirement pilot (if applicable) Contact PAKOLE Trade Kft. H-8000, Székesfehérvár, Börgöndi út, 8-10 details...
- Page 34 If you would like to contact us the type and serial number of device always be at hand. In case of other needed information write to the following address: PAKOLE TRADE Kft. H-8000 Székesfehérvár, Börgöndi út 8-10. Tel.: +36 22 316 484...
- Page 36 PAKOLE TRADE Ipari és Kereskedelmi Kft. H-8000 Székesfehérvár, Börgöndi út 8-10. www.pakole.com mail@pakole.hu Tel.: +36 22 316 484...
Need help?
Do you have a question about the ZENIT 70+ and is the answer not in the manual?
Questions and answers