Cleaning And Maintance - Carbest 811527 User Instruction

ENGLISH
SAFETY TIP-OVER SWITCH
The appliance is fitted with a tip-over switch. When you use the appliance in an upright position on a
flat and stable surface, the tip-over switch will be on. In the event the heater is knocked over, the heater
will stop functioning automatically.
OVERHEATING
- The thermostat will turn the machine off it overheats.
- Overheating can be caused by obstruction to the air intakes on the back of the machine or the grill
on the front. If this occurs please disconnect the machine and allow it to cool for 30 minutes.
Remove any obstruction and turn the machine back on.

CLEANING AND MAINTANCE

- There are no parts inside the machine that require your attention or servicing.
Do not try to open the outer case. By doing so you could damage the motor and heating element and
invalidate the warranty. If you have a problem with the heater, or if the power cord gets damaged in
any way, you MUST take the unit to a suitably qualified engineer or electrical repair centre.
- Before cleaning the machine, please make sure it is disconnected from the power supply,
and has cooled down completely.
- Never cleaning the machine, please make sure it is disconnected from the power supply,
and has cooled down completely.
- Never clean the machine with water and do not let it get wet under any circumstance.
- The outside case and be cleaned using a slightly damp lint-free cloth
(a small amount of detergent can be used if required).
- To remove any dust particles etc. form inside the front grill, or the rear air intakes,
you can use a regular vacuum cleaner.
- Always make sure the machine is completely dry before using.
- If you are not going to use the heater for a while it is best to make sure it is clean and dry
and then store it inside a plastic bag in a cool dry place.
- With sensible care and attention this heater will give you many years of good service and
economical heating.
10