Programme Options; Heated Drying; Delayed Start; Salt Indicator - Asko 1905 How To Use Manual

Programme options

Eco/Bio-function
By pressing this button you lower the
temperature in the pre-wash and main
wash to 50° C and pro-longs the main
wash by 15 minutes (programme 1–4) .
In this way you lower the energy
consumption.
Use this button, when you use detergents
with enzymes.
Temperature
By pressing
temperature in the programmes:
In The Intensive, Strong, Normal and Light wash
you can select 55, 65, 70 or 75° C.
In the other programmes you can select 45, 55 or
65° C.
Selected temperature is shown in the display for 3
seconds.
Selected temperatures remain until you alter them.
Note that 45° C will not remain.
Fan
Press this button if you want the fan to
cool down the dishes during 30 minutes
after the drying sequence.
The fan is also used to dry the dishes,
when you have selected No heated
drying.

Salt indicator

(Only for machines with water
softeners)
This lamp lights to indicate that
the machine has run out of salt.
After refilling, there may be some
delay before the lamp goes out.

Rinse aid

This lamp lights to indicate that the
machine has run out of rinse aid.
After refilling, there may be some
delay before the lamp goes out.
8
you can select

Heated drying

Lights if you have selected heated
drying. Press the pushbutton again
to cancel heated drying. Then the
lamp goes out, but the fan will dry
the dishes even without any heat.

Delayed start

If you want the machine to start after a delay
(e.g. in a cheap-rate electricity period), press
this pushbuttonthe same number of times as
you want hours´ delay (1–12 hours). Then
press the Start pushbutton. The number of
hours´ delay you have set, is displayed in the
window. Pressing the the pushbutton a
thirteenth time will reset the number of hours
tp zero.
Start / Stop
The programme starts when you press this push-
button.
Stop the programme by holding the pushbutton de-
pressed for three seconds. This is to prevent children
playing with the pushbuttons and stopping the
programme.
You can also prevent children starting the machine
by playing with the pushbuttons by programming the
machine so that it will start only if the Start push-
button is pressed and held for three seconds, see
page 9.