Petsafe Staywell 400EF Installation Manual

Before installing your cat fl ap, please read the following step-by-step instructions carefully
1
Tools Required
5
Drill holes at each corner.
9
Place the cat fl ap in the hole, with the
red 4-way lock facing inside. Mark the
screw holes.
13
Place collar
key on center of tunnel and push
fl ap. Do not force fl ap open with
magnet in hand. Fit hanging key
to your cat's collar.
Installation Guide for
2
Measure the belly height of your cat.
This is usually around 4 to 6 inches.
6
Cut along the lines using a jigsaw.
10
Remove the cat fl ap and drill holes
3
with a / " drill bit.
16
14
Temporarily tape open the cat fl ap. Sometimes
it helps for you to be on one side of the door
and your pet on the other. Use food or treats
to coax your pet through the open door. Let
the pet become familiar with passing through.
In time, remove the tape and let the fl ap hang
in the unlocked position.
4-Way Locking
Metal Door
(Wood Door Installation on Reverse)
3
Mark this measurement on the outside
of your door and draw a straight
1
horizontal line 6 / ".
2
7
Smooth out the rough edges.
11
Screw into place. Cut off
excess screw with wire cutters. Cover screw
holes with blanking plugs for neat fi nish.
Push fi t 4-way locking handle into place.
15
Using the 4-Way lock.
Magnetic
Cat Flap
4
165 mm
1
(6 / ")
2
248 mm
(9 3 / ")
4
Wood Door Installation on reverse.
The cat fl ap will not operate if fi tted to a door
containing metal e.g. uPVC coated metal doors,
metal skin doors, or security doors. The cat fl ap
must be isolated from the metal with a piece of
1
wood. Draw a square 6 / " W x 9
2
Bottom of square should be the horizontal
line from step 3.
8
1 1
Fit a 3 / " x 6 / " wooden block to
2 2
the hole.
12
The fi xed tunnel is an integral part of
the mechanism and must not be cut
or damaged. Doing so will impede the
latching mechanism.
3
/ " H.
4