Advertisement
The window for configuring the unattended installation process is displayed.
4. Choose the required operating system (Windows) along with the version,
edition and, where appropriate, service pack, and then click Next.
The configuration step Configuration of Disks and RAID Controllers is
displayed.
5. Specify the boot medium. You can select either a hard disk or an existing
RAID array or you can define a new RAID array and specify the size of the
boot partition.
If you define a new RAID array on a RAID controller which has
already been configured, the existing RAID configuration including
the data stored on the RAID array is first deleted!
6. Click Next.
The page of the wizard for configuring unattended Windows installation is
displayed.
7. Specify the required parameters for unattended Windows installation (such
as the user name, the computer name, the administrator password, the
time zone, the IP address and the SNMP settings for the ServerView
Management station).
8. Click Next.
An overview of the configured installation parameters is shown.
9. Check your specifications.
If any corrections are necessary, you navigate to the relevant
configuration step using the Back button or by selecting the step
directly in the configuration tree.
This completes configuration.
10. Leave all the media unchanged and click Start Installation to start the
installation.
Unattended installation will be performed in accordance with your
specifications.
ServerView Quick Start Guide
1.4 Example of a quick initial installation
11
Advertisement
