Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Spinera ISUP
Summary of Contents for Spinera ISUP
- Page 1 OWNERS MANUAL ISUP INFLATABLE STAND UP PADDLE BOARD Thank you for choosing SPINERA. Before using your new product, please take a minute to read the following warning and safety information. This manual is intended to alert you to potential hazards that may occur in all water...
- Page 2 SAFETY Paddle Sports can be dangerous. The user of this product acknowledges, understands and assumes the risks involved in paddle sports. The user must observe the warning labels and safety standards! WARNING For your own safety and that of your equipment, make sure to read the entire manual. Failure to follow the warning notices and instructions may result in property damage, serious injury or death.
- Page 3 Use caution: Carrying the board in windy conditions may result in serious injury or death Never use this product near other boat traffic, or watercrafts In case you sell the ISUP, please hand the manual over to the new owner. Use at your own risk!
- Page 4 SETTING UP YOUR ISUP Choose a smooth and clean surface to unfold your board. INFLATE Make sure that the valve is free of sand or dirt. Unscrew the valve cap. Push button in and turn it anticlockwise to the left, so that it pops out and is in the "OUT" position.
- Page 5 INSTALL THE SLIDE IN CENTER FIN Once the board is inflated, install the center fin. Slide the fin into the slot backwards and secure the fin with the clip (“Click”) TIGHTEN THE VALVE The valve is a service point which has to be tightened before first use and 1-2 times during the season.
- Page 6 DEFLATION STEPS Make sure that the valve is free of sand or dirt. Unscrew the valve cap. Slowly press down the button on the valve to start letting the air out of the board. There will be an initial burst of air, but that will slow down quickly.
- Page 7 Small repairs: Small leaks such as cuts or holes up to about 12 mm can be repaired with a round patch with a diameter of about 76mm. We advise you to buy a 2-component pvc glue. Use the enclosed PVC patches of your repair kit and follow the instructions of the pvc glue.
Need help?
Do you have a question about the ISUP and is the answer not in the manual?
Questions and answers