AL-KO HW 5000 FMS Premium Instructions For Use Manual page 20

en
Normal operation mode
Display indicator
A rotating X behind the normal symbolises that the pump is ON
Additional functions
Display indicator
20
Switching condition
Pump running or switched
off
Pump switches on and starts
to draw water.
Pump does not switch on
after self-test. In operation
mode, the pump does not
switch on.
Pump switches off. Dry run-
ning after 90 seconds
Pump running.
Pump switches off.
Pump switches on
Switching condition
Pump running.
Function / actions
Press the MODE button for longer than 3 se-
conds, the operating language is activated.
Change the operating language by pressing the
MODE button (30). Confirm the new language by
pressing the SET button
Initial commissioning Pump filled with water,
suction and pressure side connected, water pre-
sent on the suction side. Pump connected to
mains. Closing off devices in the pressure line
are open.
Top up with air and then press the SET button.
Carry out the initial commissioning again. For the
air pressure see technical data Page 3
Running text TOP UP 1.5 BAR
Check the suction line and then press the SET
button. Carry out the initial commissioning again.
Running text CHECK WATER INFEED
Pump delivering water. Storage vessel being fil-
led. Part of the water is being drawn off.
Pump has achieved the set switch-off pressure.
Pump has achieved the set switch-on pressure.
Function / actions
Flow rate:press the MODE button until the flow
rate appears.
Running text FLOW RATE
HW 5000-6000 FMS PREMIUM
Display indications