Warnings & Important Information; Regulatory Information; Warning About Hot Water - Rinnai MP2200 Operation & Installation Manual

WARNINGS & IMPORTANT INFORMATION

REGULATORY INFORMATION

Your Rinnai Continuous Flow water heater has been certified by the Australian Gas Association.
The A.G.A. Certification Number is shown on the data plate.
This Appliance must be installed correctly by an authorised person. The installation of gas, water, and electricity
must conform to local regulations. The installation must also comply with the instructions supplied by Rinnai.
All dimensions referred to in these instructions are in millimetres, unless otherwise specified. Please keep this
instruction booklet in a safe place for future reference.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety. Any power leads from the water heater
system components MUST BE plugged into an external weatherproof electrical outlet. If the power supply cord of
the system is damaged, it MUST BE replaced by an authorised person in order to avoid a hazard, using genuine
replacement parts available from Rinnai. Take care of not to touch the power plugs with wet hands.
Notice to Victorian Consumers
This appliance must be installed by a person licensed with the Victorian Building Authority a licensed person will
have insurance protecting their workmanship. So make sure you use a licensed person to install this appliance
and ask for your Compliance Certificate. For further information contact the Victorian Building Authority on 1300
815 127.

WARNING ABOUT HOT WATER

This appliance may deliver water at high temperature. Refer to the Plumbing Code of Australia
(PCA), local requirements and installation instructions to determine if additional delivery
WARNING
temperature control is required.
ALWAYS......
Test the temperature of the water with your elbow before placing your child in the bath, also carefully feel
water before bathing or showering yourself.
Supervise children whenever they are in the bathroom.
Make sure that the hot water tap is turned off tightly.
CONSIDER.....
Installing child proof tap covers or child resistant taps (both approaches will prevent a small hand being
able to turn on the tap).
Setting your appliance at a maximum temperature of 50°C (Contact Rinnai Australia).
NEVER.....
Leave a toddler in the care of another child. They may not understand the need to have the water
temperature set at a safe level.
Rinnai
HEATED WATER CAN BE DANGEROUS, ESPECIALLY
FOR YOUNG CHILDREN AND THE INFIRM.
WATER TEMPERATURES ABOVE 50°C CAN CAUSE
SEVERE BURNS INSTANTLY AND MAY EVEN RESULT IN
DEATH.
THOSE MOST AT RISK ARE CHILDREN, DISABLED,
ELDERLY AND THE INFIRM.
HOT WATER AT 65°C (A VERY COMMON HOT WATER
TEMPERATURE IN AUSTRALIA) CAN SEVERELY BURN
A CHILD IN LESS THAN HALF A SECOND.
AT 50°C IT TAKES FIVE MINUTES.
4 Commercial Manifold Pack OIM