Advertisement
INSTALLATION AND OPERATION MANUAL
EN
Modem EKO-LAN
MODEM DESCRIPTION
The EKOLAN modem is designed to work with controllers for solar
systems and heat pumps as well as other equipment offered by
Hewalex. The modem enables the user to communicate with the
controller through a web-based application. Components are
placed in a closed plastic housing with LEDs and sockets.
1
APPLICATION
The purpose of the system supplied along with the LAN modem is to enable:
• view of the system operating parameters,
• changes of the controller presets within the remote control scope,
• sending messages about alarm states as e-mails,
• multi-year 24-hour backup of the system operation data with the storage rate of 60 seconds,
• generating multiple statistics and diagrams related to the operation of the system,
• remote maintenance of the system which the hardware supplier provides to ensure the maximum efficiency of the system operation.
FIG.1. LAN modem - controller connection scheme
2
INSTALLATION PROCEUDRE
Installation Guidelines:
1
All installation works should be carried out after disconnecting AC main power supply.
2
Modem communication wires should be placed at a distance from high voltage wires.
3
Damaged modem wires should be replaced with the new ones.
It's required to provide access to the Ethernet network featured with dynamic allocation of IP addresses (DHCP protocol).
4
LEDs
POWER SUPPLY BY PORT MICRO USB 5V DC
+
POWER SUPPLY 12 V DC (Umax=12V, Imax=0,5A)
-
A+
COMMUNICATION WITH CONTROLLER (RS485)
B-
ETHERNET CABLE RJ-45
HEWALEX Sp. z o.o. Sp. k.
Phone.+48(32) 214 17 10
Helpline: 0801 000 810
www.hewalex.eu
10.02.2017
1/3
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Hewalex EKO-LAN
Summary of Contents for Hewalex EKO-LAN
- Page 1 The EKOLAN modem is designed to work with controllers for solar systems and heat pumps as well as other equipment offered by Hewalex. The modem enables the user to communicate with the controller through a web-based application. Components are placed in a closed plastic housing with LEDs and sockets.
- Page 2 Connection to the AC mains 2.1. It is possible to use one of the following methods: • By microUSB external power supply - voltage 5V • By external power supply- voltage 12V • Directly through the controller of the solar system – voltage 12V (see Table 2). Tab.1 Direct connection through the controller –...
- Page 3 * Check the wiring between modem and controller as well as CONTROLLER SETTINGS in the menu (Port RS485) **Check if Internet access is available, cable is connected and home network has a right configuration. Technical Support is available at ekontrol@hewalex.pl. Starting EKONTROL web application 2.5.
Need help?
Do you have a question about the EKO-LAN and is the answer not in the manual?
Questions and answers