Install The Software Driver On Pc; Pcmcia Interface Installation - Archos Cesar MPM User Manual

3..Install the Software Driver on PC

Using CESAR for the first time requires a driver installation,
depending on the version of interface (PCMCIA, USB, USB2 or Fire
Wire). Each driver installation is different.
A. PCMCIA Interface Installation
NOTE : For the PCMCIA interface, default Windows driver
are used.
The floppy disk driver is not required for this installation.
Windows 95, Windows 98, Windows 98SE & ME :
Turn on your system and wait for Windows to finish booting.
Insert the PCMCIA card (Archos logo face up) into an open
PCMCIA slot in your notebook.
A "New Hardware Found" window will guide you through
installation of driver. When prompted for driver disk,
uncheck all boxes. Then click Next.
For Windows 98 (4.10.1998) choose "The updated driver
recommended" and click Next:
Windows 2000 :
Turn on your computer and wait for Windows to finish
booting.
Insert PCMCIA card (Archos logo face up) into an open
PCMCIA slot in your computer.
Follow steps listed below to complete installation:
1. Found new hardware wizard will pop up. System will install
2. You must restart your computer before the new settings will take
effect.
ARC ATAPI,
PCMCIA IDE/ATAPI Controller,
ARCHOS SlimCDRW 8824 and
CD-ROM Drive using standard Windows drivers.
No driver files will be needed from Archos.
- 7 -