Page 1
Neo Electronics Co Limited Door Sensor SKU: NEOEDS01Z Quickstart This is a Alarm Sensor for Europe. To run this device please insert fresh 1 * CR2 batteries. Please make sure the internal battery is fully charged.1.Remove the sensor cover. 2.Make sure the sensor is powered.
Page 2
What is Z-Wave? Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section. Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
Page 3
Safety Warning for Batteries The product contains batteries. Please remove the batteries when the device is not used. Do not mix batteries of different charging level or different brands. Installation Door Sensor Installation - Option One Disassemble the door sensor main body and take out battery, fix the main body on the door with screws.
Page 4
Inclusion/Exclusion On factory default the device does not belong to any Z-Wave network. The device needs to be added to an existing wireless network to communicate with the devices of this network. This process is called Inclusion. Devices can also be removed from a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network.
Page 5
5. Don’t poll FLIRS devices. 6. Make sure to have enough mains powered device to benefit from the meshing Association - one device controls an other device Z-Wave devices control other Z-Wave devices. The relationship between one device controlling another device is called association. In order to control a different device, the controlling device needs to maintain a list of devices that will receive controlling commands.
Page 6
Size: 1 Byte, Default Value: 255 Setting Description Alarm Off 1 - 99 Alarm cancelling Alarm On Technical Data Dimensions 70 x 20 x 20 mm Weight 15.84 gr Hardware Platform ZM5202 6924715900520 IP Class IP 20 Battery Type 1 * CR2 Device Type Notification Sensor Network Operation...
Page 7
Controlled Command Classes • Basic Explanation of Z-Wave specific terms • Controller — is a Z-Wave device with capabilities to manage the network. Controllers are typically Gateways,Remote Controls or battery operated wall controllers. • Slave — is a Z-Wave device without capabilities to manage the network. Slaves can be sensors, actuators and even remote controls.