Table of Contents
Advertisement
You has to ensure that the nozzles suit the size of the abrasion media used. Replace
nozzles by unscrewing the current nozzle and screwing on a new one. Important: Before
you screw on the new nozzle, use a short burst of compressed air to clear any residual
abrasive from the hose.
Warning! Before you use a 0.4 mm nozzle, you will need to change the
receptor nozzle. Please order this as well to avoid blockages occurring.
There is a pressure regulator with integrated water separator at the rear of the instrument.
This ensures that no moisture from the compressor enters the instrument's circulation
system. It should be checked from time to time and emptied when it reaches its maximum
level. To do so, release the grey outlet knob so the water can flow down into a container.
10.3
Warranty
The warranty period for our equipment is 12 months. If faults occur within the
warranty period, contact your dental depot or get in touch directly with our service
department.
Your equipment should only be operated in perfect condition. If faults occur which
could harm operators or third parties, the unit should not be used until it has been
fixed.
This warranty does not cover damage caused by improper use, external mechanical
causes, transport damage or interference with the unit by unauthorized persons.
10.2.6
Nozzles
10.2.7
Pressure Regulator
14
Advertisement
Table of Contents
