Advertisement
GETTING STARTED
Thank you for choosing the Digit 3D LED Art Panels by Monster
Smart Illuminessence. This Design Guide will help you with
creating the design of your Digit pattern.
Please consult the Quick Start Guide for all setup and
installation instructions.
DESIGN TIPS
•
To ensure all segments light up, make sure all the connector
cables always point GREEN side AWAY from the controller.
RED always
points TOWARDS
controller
• Only one
GREEN
segment at a time (but it can be connected to any port).
• Pointing the directional markers on the back of each segment
towards or away from each other will create di erent lighting
e ects when segments are combined (colors used for reference).
• Thanks to the geometry of the mounting bracket, you can remove,
rotate, and replace a panel at any time during or after installation .
• For flush corners in square designs, use the outside ports and
keep the segment edges touching. If you want to be able to
adjust the angle of your segments within your design, leave a
gap between segment edges.
• Plan to install your Digit near enough to a power outlet for the
adapter cord to reach - ensure it is not a tripping hazard.
• Save these instructions for future reference.
plug should ever be connected to any one
GREEN always
points AWAY
from controller
1
Advertisement
