Ready To Use; Power Lamp; Error Lamp - CT PRO25S Manual

LEAD-ACID

READY TO USE

The table shows the estimated time to charge a battery from
empty to 80%
BATTERY SIZE (Ah)
40Ah
100Ah
200Ah
300Ah

POWER LAMP

MODE
If the power lamp is lit with a:
1. STEADY LIGHT
The mains cable is connected to the wall socket.
2. FLASHING LIGHT:
The charger has entered the energy save mode.
NORMAL LITHIUM SUPPLY RECOND
This happens if the charger isn´t connected to the
battery within 2 minutes or the battery voltage is
below 2V.
TIME TO 80% CHARGED
1.5h
3h
6h
16h

ERROR LAMP

If the error lamp is lit, check the following:
1. Is the chargers red clamp connected
to the battery's positive pole? Connect
the charger according to the vehicles
manual.
2. Is the charger connected to a 12V
battery?
3. Are the clamps short circuited?
4. Has charging been interrupted in
MODE
?
Restart the charger by pressing the MODE-
button. If charging is still being interrupted, the
battery...
...is seriosly sulphated and may need to be
replaced.
NORMAL LITHIUM SUPPLY RECOND
...can not accept charge and may need to be
replaced.
...can not keep charge and may need to be
replaced.
PRO25S
or
EN • 9