Advertisement
8. FACTORY RESET - LIGHT
Diablo - Press and hold the function button for approximately 12 seconds, in that time it will multi
flash and then count through 12 flashes, (the rear LED will also flash red/green), release. The rear
LED will flash once, green to confirm.
Bar Lights – Press and hold the function button until PGM 1 appears on the screen, release.
Without delay Press the function button a further 11 times to enter PGM 12, the screen will then
show RESET for 1 second.
FUNCTION
BUTTON
REAR LED
9. TO CHANGE A BATTERY IN THE REMOTE
Carefully remove the four screws, noting how tight they are. Open the case, carefully push out the
existing battery and slide in the new. Ensure the PCB and gasket align with the corner feature.
Screw on the back to a similar tightness to that noted when unscrewing.
To reconnect to the light, press the
EXPUG13.2_Sync.indd 4
EXPUG13.2_Sync.indd 4
Diablo
button.
A
Bar Lights
FUNCTION
BUTTON
12/11/2020 09:24
12/11/2020 09:24
Advertisement
