Conair BE24 Series Important Safety Instructions

IMPORTANT SAFETY
INSTRUCTIONS
WHEN USING ELECTRICAL APPLIANCES, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
TAKEN, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS
BEFORE USING APPLIANCE.
KEEP AWAY FROM WATER.
DANGER
–
TO REDUCE THE RISK OF
ELECTRIC SHOCK: ALWAYS TURN IT OFF BEFORE
CLEANING OR STORING.
WARNING
–
TO REDUCE THE RISK OF
BURNS, ELECTROCUTION, FIRE, OR INJURY TO
PERSONS:
1. Read all instructions before using the
appliance.
2. To protect against electrical hazards, do not
use while bathing or in the shower.
3. Close supervision is necessary when any
appliance is used by or near children or
by invalids.
4. Do not operate this appliance if the appliance
malfunctions or has been dropped or damaged
in any manner. Return appliance to nearest
service facility for examination, electrical or
mechanical adjustment, or repair. No repairs
should be attempted by the consumer.
5. Use appliance only for intended use as
described in this instruction book. The use
of attachments not recommended or sold by
Conair may cause hazards.
6. Do not use outdoors or operate where aerosol
(spray) products are being used, or where
oxygen is being administered.
7. Be sure mirror is not in a position where it
can reflect sunlight; reflected sunlight can
cause fire.
8. Do not use on a soft surface such as a bed,
where openings may be blocked.
9. Turn switch to OFF position before storage.
10. Do not place or store appliance where it can
fall or be pulled into a tub or sink.
11. Do not place in or drop into water or other
liquids.
12. If an appliance falls into water, do not reach
into the water.
FOR HOUSEHOLD USE ONLY
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
1. Your LED lighted makeup mirror will adjust
to different angles. Simply tilt the mirror
housing back.
2. To turn on, simply slide switch located on the
back of the mirror head to ON. After use, slide
switch to OFF position, then store mirror in a
safe location.
SPECIAL FEATURES
This lighted makeup mirror uses Lifetime Energy
Saving LED bulbs. Replacement bulbs not required.
TO INSTALL BATTERIES (not included)
1. Remove battery cover.
2. Install 3AAA new batteries as indicated on
battery compartment (fig. 1).
3. Replace battery cover by snapping it into place.
Battery
compartment
uses
3 AAA batteries
(not included)
fig. 1
When replacing the batteries, make sure you
dispose of the old batteries in accordance with
applicable regulations.
They should be disposed of in a location speci-
fically designated for that purpose so they can be
recycled safely and without posing any risk for
the environment. Do not burn or bury them.
GET TO KNOW YOUR LIGHTED MAKEUP MIRROR
1x magnification
CLOSED
3x magnification
pivoting stand
Mirror housing can tilt 90º
mirror head
rotates 90º
3x magnification
OPEN
Fold back the stand for easy storage.