Zwave EH-DS-01 Installation Manual

EH-DS-01 Door/Window Sensor Installation Guide
Introduction
EH-DS-01 has door/window sensor function, based on Z-Wave technology.
It's the Z-Wave plus product, it support the security...Those newest feature of Z-Wave technology. Z-Wave is a wireless communication protocol designed for
home automation, especially to remotely control applications in residential and light commercial environments. The technology uses a low-power RF radio
embedded or retrofitted into home electronics devices and systems, such as lighting, home access control, entertainment systems and household appliances.
This product can be included and operated in any Z-Wave Network with other Z-Wave network with other Z-Wave certified device from other manufactures
and/or other applications. All-non battery operated nodes within the network will act as repeater regardless of vendor to increase reliability of the network.
The device adopt the Z-Wave 500 series chip, when your Z-Wave network system is all made by Z-Wave 500series devices. The network system will have the
advantages as below:
∎Better RF range, improve 10 meters indoor.
∎Support 100Kbps transmit speed, speed up communication.
Frequency
Battery Type
Operating Temperature
Storage Temperature
Operating Air Range
Dimension
Function:
Add (Inclusion) Sensor
1. Remove device front cover, open the device. (Figure 1)
2. Press the function button three times in 2 seconds.
CR123A Battery
3. Led will flash three times while the network inclusion is successful (Figure 2).
Red LED
4. If inclusion failed, the sensor will go to
sleep mode. To wake the sensor again, youneed to use magnet or tamper (Figure 3) to trigger a Adding (Inclusion) process, and then sensor will
repeat steps from 3 to 4.
908.42 / 908.40 / 916.00 MHz
CR123A Battery 1 PCS
C to 50 C (32° F - 122° F)
C to 60 C (-4° F - 140° F)
Up to 148 feet line of sight
Device: 94.5 mm x 24.3 mm x 22.4 mm
Magnet: 46 mm x 12.8 mm x 13.3 mm
Figure 1
Function Button
Figure 2
Figure 3