Rammy Rotary mower maintenance instructions (3 sides).
TROUBLESHOOTING
PROBLEM
The engine does not
start
The blades not
rotating
The mower does not
cut grass
The engine is lacking
power
The mower vibrates
A Rammy mower requires proper maintenance in order for it to function safely, reliably
and for a long time.
Maintenance object
DEFECT
The machine has run out of fuel
The fuel valve is closed
The ignition switch is OFF
The switch is OFF
The belt is loose
The belt is broken
The clutch spring is broken
The drum is stuck
The blades are dull
The blades not rotating
The engine runs on half speed
Dirt in air filter
Dirty fuel
The shaft is unbalanced
Dirt or foreign objects in the
drum
Blades are broken
Activity
Grease the end bearings. The
proper dose is 1–2 strokes of the
lubricator. Excessive lubricant can
loosen the gasket. There are
grease nipples on the sides of the
bearings. Close the nipples with
plugs.
Tighten the mounting screws.
Check screw connections between
engine, transmission, and other
parts.joints of the engine, the
transmission and other parts.
MEASURE
Add fuel
Open the fuel valve
Turn the ignition switch to
ON
Turn the switch ON
Tighten the belt with the
spring or replace the belt
Replace the spring
Clean the drum and the
chamber
Sharpen the blades
Check the above
Adjust the throttle cable
Change air filter
Clean carburetor and
nooze, change clean fuel
Change shaft
Clean the drum, the blades
and the chamber.
Change blades
Type
Maintenance
interval
Bearing
10 hours
Vaseline;
working
temperature
-30... +60
degrees
2 hours after the
first start, and after
that 20 hours or one
Thread locking
season.
glue
1