Page 1
Rev. 3 SeaLED SeaLED 300 Subsea Light U S E R M A N U A L IMENCO AS Visiting Address: Stoltenberggata 1, 5527 Haugesund, Norway Office: +47 52 86 41 00 imenco@imenco.com Org No: 923 005 749 MVA Mail Address: PO.
Safety information ........................3 Warranty ............................3 General Description ......................4 Regarding these Instructions for Use ................. 4 The SeaLED 300 / SeaLED 300L Subsea LED Light ............ 4 Main Features ........................ 4 Technical Specification ......................5 Connector Configuration ..................... 5 Serial commands ......................
1.2 The SeaLED 300 / SeaLED 300L Subsea LED Light The SeaLED 300 is a high output LED light primarily designed as a ROV main / flood light. The SeaLED 300 incorporates twelve high efficient LED modules producing a proximally 12.000 Lumen, equivalent of a 600 watt halogen light.
Operating temperature range 0°C to +40°C 2.1 Connector Configuration The SeaLED 300 can be delivered with a wide range connectors and pin configurations. The configuration for this specific item is in the Quality Control document on the last page. WARNING!
SeaLED 300 - User Manual Serial commands The SeaLED 300 is supplied with a simple light GUI for setup and control: Fig. 1 – Light control GUI The GUI sends commands to the light unit, there is no feedback from the unit to the GUI.
5.2 Temperature protection: The SeaLED 300 has a built in temperature sensor which will regulate the current to the LEDs so the unit doers not overheat. Still, do not use for long periods of time on the surface or in direct sun.
If the SeaLED 300 seems to be not working properly, please try to speed up the service that Imenco can provide by describing the problem in specific terms from the person who have first handed observed the fault.