Advertisement
DA-12 Multi-Channel Digital/Analog Converter,
FRONT PANEL:
1.
Power Light
2.
Lock Light
3.
Signal Light
REAR PANEL:
1.
AC Input and
Mains switch
2.
Digital Input
3.
Analog output 1-8
4.
Analog output 9-12
5.
SYNC Source switch
ANALOG OUTPUT FINE TUNING:
1.
Each channel has a multi-turn trimpot to trim a small amount of gain to compensate for slight circuit
variations. To access, remove screws on top cover of unit and remove top cover completely. The
trimpots are a small blue component mounted on the main PC board. To adjust level, turn small
screw with alignment tool for desired trim. The usable range is +/- 0.5 dB.
Digital Cinema Theatre System
Operation Guide
Indicates AC voltage input.
Detects valid AES/EBU lock data on selected AES pair
Detects valid analog signal output on indicated channel
100~240 VAC volt, 50/60 cycle AC input on IEC socket
DB-25 connector. Wired to AES input standard (see page 2)
DB-25 connector. Wired to Tascam pinout standard (see page 2)
DB-25 connector. Wired to Tascam pinout standard (see page 2)
Rotary control. Selects AES pair input for digital sync. Selectable from 1-
6. Set from factory for pair #1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Apogee DA-12
Summary of Contents for Apogee DA-12
-
Page 1: Operation Guide
DA-12 Multi-Channel Digital/Analog Converter, FRONT PANEL: Power Light Lock Light Signal Light REAR PANEL: AC Input and Mains switch Digital Input Analog output 1-8 Analog output 9-12 SYNC Source switch ANALOG OUTPUT FINE TUNING: Each channel has a multi-turn trimpot to trim a small amount of gain to compensate for slight circuit variations. - Page 2 WIRING SPECIFICATIONS: Analog output pinout: (Wired to same standard as Tascam analog output) Channel + AES Digital input pinout: Channel + Ground Ground...
Need help?
Do you have a question about the DA-12 and is the answer not in the manual?
Questions and answers