Page 1
¬ DC Power Supplies ¬ High Voltage Detector ¬ Calibrators ¬ Gas Analysers ¬ Frequency Counter ¬ Function Generator MODEL - 287SVD ¬ Phasing Sticks ¬ Battery Tester ¬ Waterproof Pen Testers ¬ Solar Power Meter ¬ EMF Detector ¬ Wood, Paper & Grain Moisture Meter ¬...
Page 2
® ® INTRODUCTION The personal safety voltage detector is a sensor for ● Equipped with self-testing functions. sensing AC High Voltage. It provides electric engineering ● Sound & flash light warning on different frequencies personnel, power engineering personnel, firefighting varied positively with sensed voltages. personnel &...
® ® SPECIFICATION METHOD OF USE ● Distance of starting warning: 1. Inspection before use (1) Check the appearance & structure for any 85cm for 22.8kv (phase to phase) abnormality. ● Applicable Frequency : 50 / 60Hz (2) Press Self-Test switch (about 10 seconds) to confirm all functions are working normally.
Page 4
® ® (3) Wear the unit to the outer side of forearm with the 2. Replacing Battery : sensing side faces outwardly. 1. When the sound become weak, the battery shall be replaced. 2. Use coin to open battery cover & remove used battery.
Page 5
® ® 4. Do not store this instrument outdoor or inside of car COMBINATION OF THE DETECTOR for long time to avoid direct sunbeam & high ● Separate the elastic cord and the elastic cord temperature. adjustment. 5. The instrument shall not be dropped or impacted heavily.
Page 6
® ® ● The hook can be disassembled. 1. Before assembling the connection ring, take the (1) The combination of the hook, upper part of the connection ring pass through the Sealed elastic cord & one side of the detector. Assemble for stuck the connection ring firmly.
Page 7
® ® ● Attention : this elastic cords strip must be “A” side 2. Take three buckles pass through the elastic cord from “B” side. THICK THIN “B” 3. Turn over the elastic cord & take the elastic cord adjustment pass through from “B” side. Correct Incorrect Stuck !!
Page 8
® ® 4. First assemble the connection ring of the other side. ● Attention : The second combination is different. 7. Use the elastic cord adjustment to adjust the length 5. Take the elastic cord “B” side pass through the of the elastic cord, then assemble the hooks.
PERSONAL SAFETY VOLTAGE DETECTOR detector. Assemble the connection ring firmly. This Test Certificate warrantees that the product has been inspected and tested in accordance with the published specifications. 287SVD MODEL NO. ___________ SERIAL NO. ___________ ● Assemble the DATE: ___________...
® ® WARRANTY Each “KUSAM-MECO” product is warranted to be free from returned to a “KUSAM-MECO” authorized service center within defects in material and workmanship under normal use & service. the warranty period. The warranty period is one year (12 months) and begins from the THIS WARRANTY IS BUYER’S SOLE AND EXCLUSIVE...