6 H.P. Briggs and Stratton or 5.5 H.P. Honda. The log splitters can be used in the vertical or horizontal position. The 2" ball hitch allows the log splitter to be towed by ATVs, utility vehicles, small tractors, etc.
If you have any questions not answered in this manual or require additional copies or the manual is damaged, please contact your dealer. The Safety Alert symbol identifies important safety messages on the Log Splitter and in the manual. When you see this symbol, be alert to the possibility of personal injury or death. Follow the instructions in the safety message.
2.2 SAFETY WEAR NEVER wear loose clothing or jewelry that can be caught by moving parts of your Log Splitter and pull you into it. Keep clothing away from all moving parts of your Log Splitter. Wear proper head gear to keep hair away from moving parts.
Log Splitter while in operation. 5. Keep work area clean. Immediately remove split wood around your Log Splitter so that you don’t stumble over it. 6. When using your Log Splitter, use in daylight or under good artificial light.
To do so may result in crushed or amputated fingers or worse. You may lose an arm or foot. ♦ ♦ ♦ ♦ ♦ DON’T straddle the Log Splitter when using it. A slip in any position could result in a serious injury.
NEVER carry any cargo or wood on your Log Splitter. It may fall off and endanger vehicles that are following you. Allow for added length of your Log Splitter when turning, parking, crossing intersections and in all driving situations. Be careful when backing up. You can easily jack- knife your Log Splitter.
Log Splitter is running. Hot oil under pressure could result in serious injury. The pressure relief valve on your Log Splitter is preset at the factory. DO NOT adjust the valve. Only a qualified service technician should perform this adjustment.
NOTE: The following instructions pertain to Gearmore Log Splitters, models T22B & T22H. This Log Splitter comes partially assembled. Refer to the drawing and parts list should it become necessary to disassemble the unit for repair or replacement of parts.
ASSEMBLY GUIDE LOG SPLITTER ASSEMBLY GUIDE Compact Log Splitter in crate. Crate with side board in place to provide support. (see steps 1 - 4, pg. 8). Wood block under tank to keep it upright. Cylinder pushed all the way back and stripper plate attached (see steps 6 - 7, pg.
ASSEMBLY GUIDE Log Splitter locked down in horizontal position (see step 9, pg. 8). Log Splitter with hoses connected and valve handle in position (see steps 10 - 11, pg. 8).
IMPORTANT: The engine and hydraulic tank are shipped without oil. See the engine operating and maintenance instructions manual packed with your Log Splitter for the type of crankcase oil, fuel, etc. The engine manufacturer recommends lead- free gasoline only. CAUTION: DO NOT START OR RUN...
"OK" range. TOWING The Log Splitter is equipped with road speed tires, a Class I coupler (2" diameter ball required) and safety chains. Before towing, the safety chains must be secured to the hitch or bumper of the vehicle.
DANGER: KEEP HANDS AND FEET CLEAR OF RAM, STRIPPER PLATES AND BASE PLATE AT ALL TIMES. 1. Set up the Log Splitter in a clear, level area and block the wheels. Make sure that the suction port on the tanks is always on the lower side of the Log Splitter.
MAINTENANCE By following a good maintenance program, your equipment will last for many years. Consult the operating and maintenance instructions of the engine manufacturer for engine care and maintenance. Always check the oil level of the hydraulic reservoir before operation. Operating the Log Splitter without an adequate oil supply will cause severe damage to the pump.
LIMITED WARRANTY GEARMORE, INC., warrants each new Gearmore product to be free from defects in material and workmanship for a period of twelve (12) months from date of purchase to the original purchaser. This warranty shall not apply to implements or parts that have been subject to misuse, negli- gence, accident, or that have been altered in any way.