PRODIS M587 Instruction Manual page 11

15. Insert 2 x AA batteries into the battery compartment.
16. Close the battery compartment cover.
Installation
17. Locate the area you would like to install the dummy camera, and
secure in place with the screws included. If the site is of stone or brick
construction, make sure that you use the two raw plugs included.
Note: the camera could be used indoor or outdoor.
18. When you wish to operate the dummy camera, simply remove the
battery compartment cover and flick the on/off switch to the on position
and replace the cover. Straight after the batteries are inserted, the
security light will flash and it will pan right and light for a test program of
60 seconds to ensure that it is able to rotate up to its maximum
allowance without obstruction. When any further movement is
detected, it will pan right and left for a 20 second period, after
movement was detected. When you wish to switch the camera off,