URBANGLIDE MOTO CROSS 2.0 User Manual page 9

Replace the chain (15min)
1. Using the screwdriver,
unscrew the screws on the
guard and remove the chain.
4. With two 14mm and 17mm wrenches, detach the axial part,
remove the chain and disassemble the wheel from the
motorcycle.
6. Screw the brake cable
back onto the wheel and
check that it is working
properly.
2. Using the 10 mm wrench and screwdriver,
unscrew the brake cable and disconnect it from the
wheel.
7. Install the brake spring, and
then run the brake cable inside.
Replace the set as originally.
5. Replace the chain by joining the
wheel and the axial part between
them.
8. Apply the brake securely with
the 10mm wrench. Test and
adjust if necessary.
9