Advertisement
Quick Links
WOODEN RADIO-CONTROLLED GRANDFATHER CLOCK WITH
MD693/ HD-1688
PLEASE READ ALL THE INSTRUCTIONS CAREFULLY BEFORE YOU SET YOUR
CLOCK GOING AND ENSURE YOU KEEP HOLD OF THESE INSTRUCTIONS SHOULD
YOU NEED TO REFER TO THEM.
- PRIOR TO USE: Please remove the pointer at the centre of the movement, located on
the back of the clock, to ensure that the clock works once the batteries are inserted.
- The assistance of a second person is required for the assembly of the clock.
DESCRIPTION OF THE CLOCK AND ITS ELEMENTS
Description of the elements that make up this clock:
A
Base (x1)
Left-hand case side (x1)
B
C
Right-hand case side (x1)
D
Rear door (x1)
Fixings
J
Screws and washers
(x8)
"WESTMINSTER" CHIMES
INSTRUCTIONS
E
F
Top section
G
Cover for the battery
compartment (x1)
H
I
K
Long screws for the glass door (x2)
Glass door (x1)
(x1)
(clock)
Pendulum (x1)
Weight (x2)
Chain (x1)
Advertisement
Related Manuals for PRODIS MD693
Summary of Contents for PRODIS MD693
- Page 1 WOODEN RADIO-CONTROLLED GRANDFATHER CLOCK WITH MD693/ HD-1688 “WESTMINSTER” CHIMES INSTRUCTIONS PLEASE READ ALL THE INSTRUCTIONS CAREFULLY BEFORE YOU SET YOUR CLOCK GOING AND ENSURE YOU KEEP HOLD OF THESE INSTRUCTIONS SHOULD YOU NEED TO REFER TO THEM. - PRIOR TO USE: Please remove the pointer at the centre of the movement, located on the back of the clock, to ensure that the clock works once the batteries are inserted.
-
Page 2: Technical Specifications
ASSEMBLY OF THE CLOCK Position the left-hand case side (B) Do the same for the right-hand Position the rear case (D) into the on the base (A). case side (C) (the one with the grooves located inside the case Screw in the two screws (J) hinges). -
Page 3: Setting Up The Clock
SETTING UP OF THE PENDULUM Before hanging the pendulum, remove the plastic packaging from around the metal chains and fasten the weights (I) to the latter. Comment: The weights are for decorative purposes only and must not be placed in the middle as this is where the pendulum is sited. Next, pull the cover of the battery compartment (G) upwards. - Page 4 Locate the movement (a) and remove the pointer at the centre of the latter to ensure that the clock works once the batteries are inserted. Install the LR06 battery in the movement’s battery compartment (a4), respecting the polarities indicated on the base of the compartment. A few seconds after the batteries are inserted, the hands will turn.
-
Page 5: Important Advice
REBOOTING Using the tip of a pen press the “RESET” (a2) button to reboot the clock. The hour, minute and second hands automatically reboot at the 12:00 noon position and enter into automatic signal reception mode. SETTING THE CHIME (WESTMINSTER CHIMES): This clock is set to chime from 06:00am to 21:00pm. - Page 6 This symbol indicates that electrical and electronic devices are collected selectively. The symbol shows a waste container crossed out with an X symbol. Imported by Prodis SAS 1 rue de Rome 93110 ROSNY SOUS BOIS- France/ Made in PRC Marketed by EUROTOPS VERSAND GMBH D-40764 LANGENFELD...