Advertisement
Washing your brush bars
To maintain optimum performance, check and wash the brush bars regularly.
Remove brush bars
Don't put any part of your machine in a dishwasher or use detergents, polishes or
air fresheners.
Press the cleaner head release button to remove it from the wand.
Pull the brush bars off the end cap and put the end cap to one side, don't wash it.
Wash and dry brush bars
Hold your brush bars under cold tap water and gently rub to remove any lint
or dirt. Keep washing until the water runs clear.
Stand the brush bars upright and leave for at least 24 hours to dry.
Replace your brush bars
Make sure your brush bars are completely dry before refitting.
Each brush bar is engineered to correspond to a specific position on the end
cap. It is important that both brush bars are fitted in the correct position.
Slide the assembled brush bars back into the cleaner head.
Push the end cap until it clips securely back into the closed position.
The cleaner head housing is not washable and should only be wiped over
with a damp lint-free cloth.
The brush bar release button is located on
the top of the cleaner head and the brush
bars slide out of the same end.
The fittings on the end cap
are either side of a central
point that locks into the
cleaner head. One fitting
is larger than the other
and the ends of the brush
bars will only fit on the
corresponding fitting.
clik
clik
Advertisement
