Behringer BCD-2000 Manual page 3

To use the BCD-2000's controls, you have to activate it in the DEX/RED Mobile configuration as well. To
do this, open the options window, and select the General tab.
There you can check the Behringer BCD-2000 option. On the bcd-2000 config panel, you can then
connect/disconnect the bcd-2000.
-The PFL Mix knob fades between channels sets the behavior of the PFL Mix knob. If this option is
selected, then the volume will gradually fade from cueing one deck to cueing the other. In the center
position you will hear both decks.
If this option is not selected, then the pfl mix knob will switch between deck a and deck b. In the center
position, neither will be audible.
-Disable Synch Button flashing will disable the synch button from flashing on the beat if you find this
distracting or inaccurate.
-Pitch Slider Relative mode will switch between a relative or an absolute pitch slider. Absolute means
that the center of the pitch slider will always be 0%. This means it can't be used in combination with
automatic bpm matching. Relative mode is default, and it means that the pitch will increase/decrease
from the current pitch as you move the pitch slider, whatever absolute position the pitch slider was on.
This means that the center position on the pitch slider may not always be 0% song pitch.
-Jog Wheel sensitivity sets the sensitivity of the jog wheel. The default is 100, increasing it will make
the pitch respond harder on small wheel movements.
-Default Effect sets the default effect when starting DEX/RED Mobile to be controlled by the effect
section on the bcd.
Use the play button to start or pause a track. Pausing a track will also set the current cue point.
Use the cue button to stop the track. This will return it's position to the current cue point.
The crossfader and volume sliders will adjust the volume as expected, and so will the low, mid and
open in browser PRO version pdfcrowd.com
Are you a developer? Try out the HTML to PDF API