Cleaning/Maintenance/Storage - Gardeo GMTBE1506W Original Instructions Manual

Warning! The tines will
continue to turn for a few
seconds after the tool has
been switched off.
Do not touch the rotating
tines injury hazard!
Always keep a firm grip on the tool with
booth hands and watch your feet The tines
may cause an accident.
Be careful while moving backwards –
danger of tripping!
Do not touch the gearbox
(H 21) - as it may become hot
during operation
danger of burns!
To avoid damage to the tool:
• Never lift or drag the tool with the
motor running.
• Use the transport position when
transporting the lawnmower (see
"Working position/Transport posi-
tion").
• Raise the device to transport it
over stairs.

CLEANING/MAINTENANCE/STORAGE

Warning! Always return the
tool to the service centre for
work not described in the
manual. Only use original
Switch the tool off, unplug it
from the mains, and wait for
the tines to stop moving
before carrying out any main-
tenance or cleaning work on
Perform regular maintenance
and cleaning on the tool. This
will ensure long, reliable
OPERATING INSTRUCTIONS
parts.
the tool.
service.
To avoid injuries and
damage: Switch the tool off
after working with
it and for transport;
disconnect from the mains
and wait for the tines to
• Walk the tool through the soil at normal pace
and in a line as straight as possible.
• Always work away from the mains socket.
Make sure that the cable is kept well away from
the working area.
• Always run the extension cable behind you
and, after turning, move it to the side already
worked.
• Overload protection: The motor will cut out
immediately if overloaded. The tool cannot
be used until it has completely cooled down
again.
General cleaning and mainte-
nance work
• Do not spray the tool down with water
(especially not under pressure), and do not
clean it under running water. There is
a risk of electric shock and the equipment could
be damaged.
• Before each use, check the equipment for
obvious defects such as lose, worn or damaged
parts. Check that all nuts, bolts and screws are
sitting firmly.
• Check covers and safety devices for damage
and check that they are sitting correctly.
Replace them if necessary.
stop moving.