Advertisement
Figure 13. Loader Blade secured with Lift Chain
LOADER CROSS-BRACE
Lift Chain secured with Grab Hook
Attach Lift Chain to Loader • (If Loader Tilt Cylinders have been disconnected for Power Angle)
1.) Find a secure spot on the Loader Cross-Brace to wrap Lift Chain (1TBP31) around. The Chain should go
over the Top of the Cross-Brace and wrap underneath. Refer to Figure 13 above. Be certain Chain will not
pinch or damage any hydraulic lines or other parts of the Loader.
2.) Cut Chain to length and install supplied Grab Hook (1TBP77) to the Chain with Anchor Shackle (1TBP31)
provided. Hook back onto the Chain.
11 of 14
Advertisement
