④ Overturn-Prevention Clamp - Panasonic TY-ST42P50 Fitting Instructions Manual

Assembly Procedure
3. Display Overturn-Prevention
● Anchor the display to both the base and the wall surface.
① Anchoring to the base
Attach the overturn-prevention belt ① (1 belt) and overturn-prevention clamp ④ (1 clamp) to the pedestal
using a screw ② (1 screw) through the screw hole at the rear of the pedestal, and then use a wood screw ③
(1 screw) to anchor the belt to the base.
When attaching to the base, insert the wood screws into the prepared holes.
If there are no prepared holes, drill new holes to the center of the base board width.
(Screw ② tightening torque: 1.2 to 1.5 N•m)
Screw ②
Overturn-prevention
clamp ④
Front face
② Anchoring to the wall
Use a sturdy string, wire, or other such
commercially available item through the
holes on the overturn-prevention clamp,
and anchor the string etc. to a secure
wall or pillar.
[For safety reasons, always use the overturn/fall prevention accessories]
The equipment may overturn in the event of an earthquake etc. Therefore, always use the overturn/fall
prevention accessories.
The details in this section indicate how to reduce any damage or injury caused by this equipment
overturning or falling due to an earthquake. However, there is no guarantee that the overturn/fall
prevention accessories will be effective in all earthquake situations.
16
Wood
screw ③
Overturn-prevention
belt ①
(Cont'd)
Screw ②
Overturn-prevention
clamp ④
Locate the wood screw
at the center of the
material width.
Overturn-prevention
clamp ④
Overturn-prevention
belt ①
Wood screw ③