Panasonic TY-WK85PV12 Installation Instructions Manual page 14

Components
TY-WK85PV12 Wall-hanging bracket (Vertical mounting type)
Wall-hanging bracket
Base unit (L)
L
Joints (long) (2)
Joints (short) (2)
Points to note during installation
The wall-hanging bracket is for use in installing the Plasma Display to a vertical wall for viewing
purposes. Do not use it for any type of installation other than vertical wall installation.
In order to ensure correct, problem-free operation of the Plasma Display, do not install the Display in
any of the following places.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
When installing this wall-hanging bracket unit, use a fixing method appropriate to the type of wall.
Fit so there is no contact between the attachment bolts or power cord and any metal inside the wall.
Insert the power cord plug for the Plasma Display into a wall outlet which is close and easily accessible.
Provide adequate ventilation so that the temperature around the display does not rise above 40 °C
(104 °F). If there is insufficient movement of the air inside display, heat may build up inside the
display, and fire may result.
Spread a soft blanket or cloth over the floor so that the plasma display and floor will not be marked
or scratched during the assembly and installation work.
When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened.
Take sufficient care to ensure safety around you when performing the assembly and installation work
or while moving about during the course of the work.
Do not use any components other than the packaged ones.
14
Wall-hanging bracket
(1) Base unit (R)
R
Screws for assembling
(1) the wall-hanging bracket
M6×30
Flat countersunk head screws for
securing the joints
M4×8
Gasket for the wall-hanging brackets (4)
Grounding fitting
Gasket for the grounding fitting
(8)
(4)
(2)
(2)