Table of Contents
Advertisement
Available languages
Available languages
� Never touch the mains plug with wet hands.
� Do not run over, crush or pull the power supply
cable or extension lead, otherwise it may be
damaged.
Protect the cable from heat, oil and sharp edges.
� The extension lead must have a cross section in
accordance with the operating instructions and be
protected against splashed water. The connection
must not be in water.
ELECTRICAL SAFETY
� Motor Protector fitted! Motor fitted with safety
overload protection. If motor stops working,
allow a few minutes to cool, before restarting.
� Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut,
damaged or entangled.
Your machine is double insulated for safety and
requires no earth connection. The operating voltage
is 230 V AC, 50 Hz (for non-EU countries 220 V,
240 V as applicable). Only use approved extension
cables. Contact the Centre for details.
If you want to use an extension cable when
operating your product, only the following cable
dimensions should be used:
– 1.0mm2: max. length 40 m
– 1.5 mm2: max. length 60 m
– 2.5 mm2: max. length 100 m
Note: If an extension cable is used it must be
earthed and connected through the plug to the earth
cable of your supply network in accordance with
prescribed safety regulations.
If in doubt contact a qualified electrician or the
nearest Service Center.
� WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and socket
must be of watertight construction and intended
for outdoor use.
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
MAINTENANCE
� Keep all nuts, bolts and screws tight to ensure that
the leaf blower/garden vacuum is always in a safe
working condition.
� The leaf blower/garden vacuum should be stored
in a dry, high or locked up place out of the reach of
children.
� Replace worn or damaged parts for safety.
� Check the collection bag frequently for wear or
deterioration.
� Do not attempt to repair the machine unless you
are qualified to do so.
DESCRIPTION
Your blower vac has been designed for leaf
clearing. This tool is intended for consumer and
outdoor use only.
1)
Handle
2)
Switch trigger
3)
Power cable and plug
4)
Belt
5)
main housing
6)
Function switch
7)
Upper tube
8)
Lower tube
9)
Wheel bracket
10) Wheels
11) Collection bag
12) Hook for bag
13) Cable hook
14) Bag connection
MOUNTING THE TUBE
_
Connect both parts of the tube as shown.
_
Slide the tube into the housing .
_
Fit the tube using the screws.
_
To remove the tube, remove the screws
and pull the tube out of the housing.
Switch off and unplug the
appliance before mounting or
removing the tube.
MOUNTING THE COLLECTION BAG
_
Place the collection bag (11) onto the connection
(14). Make sure to slide the collection bag opening
past the raised edge.
_
Fit the brace to the suspension point.
SELECTING THE OPERATING MODE
Select the required operating mode before
use (blowing or vacuuming).
_
For blowing, turn the switch (6) to the
blowing symbol.
_
For vacuuming, turn the switch to the
vacuuming symbol.
20
Advertisement
Table of Contents
