Advertisement
2011 Scramble Keyboard
Step
Determine an appropriate mounting location. The vertical panel to which the keyboard is to be mounted may be
1
anything up to 45mm thick but must also be strong enough to take the weight of the keyboard and the heaviest of
key pushing that may occur
Cut an accurate aperture for the keyboard. An escutcheon plate is available to cover roughly cut edges
2
Select the required lug from the table below:
Fit the screws through the keyboard enclosure and using the special tool provided screw them into the lugs. Rotate
3
the lugs anti-clockwise to position the lugs against the sides of the keyboard
4
Route the cable from the keyboard to the controller.
Insert the keyboard though the aperture in the panel. Then tighten the screws using the special tool provided. This
5
rotates the lugs in to position behind the panel.
6
Test the operation of the keyboard.
7
Fit plastic anti tamper rings
For further details and assistance contact us on 01254 883348 or email us at:
WEEE
Certificate Number WEE/JG2915VS
Copyright BSB Electronics Ltd TA Progeny Access Control
2013 All rights reserved.
Document Number: MAN0029
Description
support@progeny.co.uk
www.progeny.co.uk
Issue: 3.03
Page 3 of 3
Advertisement
