Table of Contents
Advertisement
EGS-MX1
Flow Control
VT-UTF8 Combo Key Support
Recorder Mode
Resolution 100x31
Putty KeyPad
3.6.2.10.2 Legacy Console Redirection Settings
Item
Redirection COM Port
Resolution
Redirect After POST
66 EGS-MX1 Quick Reference Guide
None[Default]
Hardware RTS/CTS
Disabled,
Enabled[Default]
Disabled[Default],
Enabled
Disabled[Default],
Enabled
VT100[Default]
LINUX
XTERMR6
SCO
ESCN
VT400
Option
COM0[Default]
80x24[Default]
80x25
Always Enable[Default]
BootLoader
Flow control can prevent data loss from buffer
overflow. When sending data, if the receiving
buffers are full, a 'stop' signal can be sent to stop
the data flow. Once the buffers are empty, a
'start' signal can be sent to re-start the flow.
Hardware flow control uses two wires to send
start/stop signals.
Enable VT-UTF8 Combination Key Support for
ANSI/VT100 terminals.
With this mode enabled only text will be sent.
This is to capture Terminal data.
Enables or disables extended terminal resolution.
Select FunctionKey and KeyPad on Putty.
Description
Select a COM port to display redirection of
Legacy OS and Legacy OPROM Messages.
On Legacy OS, the Number of Rows and
Columns supported redirection.
When Bootloader is selected, then Legacy
Console Redirection is disabled before booting to
legacy OS. When Always Enable is selected,
then Legacy Console Redirection is enabled for
Advertisement
Table of Contents
