Gardeo GMTBT38HP35BS Operator's Manual page 30

ASSEMBLY
Following the assembly directions below, you
will assemble the front tine tiller in a few
minutes.
Wheels
Slide the tube sleeves into the wheels. Mount
the wheels on both sides of the bracket with
M8 flange screws, washers and flange nuts.
Attach the wheel covers.
Lower handles
1. Remove the M8X250 screw, flat washer and
lock nut from the rear end of the tiller chassis.
2. Mounting holes for adjustment knob are
arranged in the top portion of each lower
handle.
Make sure the 3-hole side of the handle is
facing inward. Insert the bottom portions of the
lower handles into the mounting channels
located in the underside of each side of the
tiller chassis.
3. Mount the flat washer on the M8X250 screw.
Line up the holes in the bracket, handles and
tiller chassis. Slide the screw through the holes
from one side, then lock nut from the other
side. Tighten down.
M8 60 2
Tailpiece & depth rod brackets
Mount the depth regulator rod bracket on the
tailpiece bracket with two M8X20 flange
screws and flange nuts.
A
Tilling tines
Place tilling tines on the tine shaft on both
sides of the gear box. Line up the holes in the
tine frame sleeves and tine shaft. Insert O8X40
clevis pins through the holes in tine frames and
tine shaft.
Insert O2.5 cotter pins through the holes in the
clevis pins to secure them.
M8 20 2
8 40 2
2.5 2
B
C