Rompa 18041 Manual

CONTENTS

1 package containing:

three pin wheels E: large, medium, small
one ground stake C
one connecting rod A
three spacers (on the connecting rod) F
one end cap (secured to connecting rod) D
ASSEMBLY & INSTALLATION
Remove the end cap and spacers from the connecting
rod.
Place the largest pin wheel onto the connecting rod
followed by a spacer.
Repeat for the medium and small pin wheels and
finish by placing the cap on the end of the connecting
rod. For a permanent fixing a drop of glue could be
used to secure this cap.
Position the stake in the ground where required and
slot the connecting rod into the ferrule B.
Alternatively secure the pin wheel to a fence or similar
by using U-shaped clips (to be purchased separately)

SAFETY

Always supervise the use of this product.
For decorative use only.
For three years and above.
CARE & MAINTENANCE
The colours will eventually fade after repeated exposure to sun and rain. You may wish to bring
the pin wheel indoors during bad weather e.g. during the winter to prolong the life of your pin
wheel.

SPECIFICATION

Nylon
Wheels: 21cm/28cm/38cm
Wind range: 1 – 20mph
PIN WHEEL 18041
Copyright ROMPA® Ltd
PIN WHEEL 18041, KH 9.03